Abstract:Numerous fluorine-containing hazardous solid wastes from the electrolytic aluminum process pose a serious threat to the ecosystem and human health. Currently, in the study of leaching on these wastes, Al and F are usually recovered by adjusting the pH of the leaching solution to precipitate aluminium hydroxyfluoride hydrate, which can be used to produce aluminum fluoride by roasting. However, aluminium hydroxyfluoride hydrate is often mingled with cryolite and other impurities when precipitating, which ultimately affects the purity of obtained aluminum fluoride by calcination. Interestingly, herein, the aluminium hydroxyfluoride hydrate residue was digested by fluorosilicic acid to effectively remove impurities and obtain a pure aluminum fluoride solution, from which the β-AlF3 product was produced by crystallization at a high-temperature. The results show that under the conditions of a temperature of 60 °C, time of 35 min, initial fluorine-aluminum molar ratio of 3:1 and initial concentration of fluorosilicic acid of 18 %, the gross yield of fluorine is 86.2 %, and the recovery of silicon in the form of SiO2 is 95.2 %. During crystallization, the product changes from AlF3·3H2O to β-AlF3 with the increase of temperature. Under the conditions of a crystallization temperature of 150 °C, an initial concentration of aluminum fluoride of 191.10 g/L and a stirring speed of 200 rpm, β-AlF3 of an average particle size of 43.22 μm was obtained by adding 5 % seed. The contents of Al and F in β-AlF3 products are 32.57 % and 61.49 % respectively, which meet the requirements of GB/T 4292–2017 (AF-0) about National Standards of China. According to DFT calculation, the β-AlF3 tends to adsorb two or three water molecules in its cavity structure, which explains why the crystallized β-AlF3 contains water of 5.10 % at 180 °C.

Evaluation Strategy and Mass Balance for Making Decision about the Amount of Aluminum Fluoride Addition Based on Superheat Degree

A Data and Knowledge Collaboration Strategy for Decision-Making on the Amount of Aluminum Fluoride Addition Based on Augmented Fuzzy Cognitive Maps

Optimization of Aluminum Fluoride Addition in Aluminum Electrolysis Process Based on Pruned Sparse Fuzzy Neural Network.

Control of Temperature and Aluminum Fluoride Concentration Based on Model Prediction in Aluminum Electrolysis

Determination of Fluoride Component in the Multifunctional Refining Flux Used for Recycling Aluminum Scrap

The fuzzy control of alumina concentration in aluminum reduction cells

Diagnosis Method For The Heat Balance State Of An Aluminum Reduction Cell Based On Bayesian Network

A Superior Technology for Removing Fluorine from Spent Cathode Carbon: Optimization of the Process by Response Surface Methodology

Evaluation of fluoride emissions and pollution from an electrolytic aluminum plant located in Yunnan province

Relationship between alumina mixing characteristics and feeder configurations in aluminum reduction cells

Formation of Aluminum-Fluoride Complexes Compromises Defluoridation Efficiency of Aluminum-Based Coagulation.

Superheat Degree Recognition of Aluminum Electrolysis Cell Using Unbalance Double Hierarchy Hesitant Linguistic Petri Nets

Quantitative Analysis of Complex Aluminum Electrolytes by X‐Ray Fluorescence

An Estimation Model Of Alumina Concentration For Point-Feeding Aluminum Reduction Cells

Preparation of β-AlF 3 from fluorine-containing wastes: Leaching with fluorosilicic acid and crystallization

Numerical Simulation and Combination Optimization of Aluminum Holding Furnace Linings Based on Simulated Annealing

Study on preparation of aluminum fluoride from cryolite

Operational Decision-Making Optimization of Aluminum Electrolysis Process Based on Health Evaluation of Aluminum Electrolytic Cell

Preparation of Β-Alf3 from Fluorine-Containing Wastes: Leaching with Fluorosilicic Acid and Crystallization

Numerical Simulation on Melt Flow with Bubble Stirring and Temperature Field in Aluminum Holding Furnace

A Soft Sensing Prediction Model of Superheat Degree in the Aluminum Electrolysis Production