Abstract:Establish a robust calculation model and enhance the accuracy of the XRF method for complex aluminum electrolytes by investigating the correlation between fluorescence intensity in XRF spectra and elemental contents. Propose a practical solution for determining cryolite ratios (CR) using XRF with an average deviation as low as 0.02. The future production of electrolytic aluminum will be characterized by low temperature, low carbon emissions, and environmental friendliness, which will result in a more complex electrolyte system. Real‐time analysis of electrolytes can significantly enhance the efficiency of the electrolytic process. However, accurately analyzing the composition of complex aluminum electrolytes online has been a technical challenge. This research primarily focuses on determining the ingredient contents of complex aluminum electrolytes based on elemental concentrations measured using X‐ray fluorescence (XRF) according to an applicable standard. Calibration curves were established based on 53 standard samples of complex aluminum electrolytes to establish relationships between XRF fluorescence intensity and real concentrations. Analysis conducted on industrial complex electrolytes confirms that these newly constructed curves effectively reduce relative errors to less than 3%. Additionally, a feasible solution is proposed for determining the cryolite ratio (CR) in aluminum electrolytes using XRF. Results demonstrate an average deviation as low as approximately 0.02, fully meeting industrial production requirements. This technique offers numerous benefits including rapid analysis, ease of use, and cost savings.

Control of Temperature and Aluminum Fluoride Concentration Based on Model Prediction in Aluminum Electrolysis

Anode Effect Prediction Based on Collaborative Two-Dimensional Forecast Model in Aluminum Electrolysis Production

The fuzzy control of alumina concentration in aluminum reduction cells

A Soft Sensing Prediction Model of Superheat Degree in the Aluminum Electrolysis Production

Progress in Aluminum Electrolysis Control and Future Direction for Smart Aluminum Electrolysis Plant

Development of fuzzy expert control technique for aluminum electrolysis

Improved CFD Modeling of the Whole-Cell Side Ledge Behavior in Aluminum Electrolysis Cell

An Estimation Model Of Alumina Concentration For Point-Feeding Aluminum Reduction Cells

Prediction model of superheat in aluminum electrolysis based on time granularity

A Method for Anode Effect Prediction in Aluminum Electrolysis Cells Based on Multi-scale Time Series Modeling

Estimating the Alumina Concentration During Aluminum Electrolysis by Identifying the Sensitive Frequency Band Using Marginal Kurtosis

Evaluation Strategy and Mass Balance for Making Decision about the Amount of Aluminum Fluoride Addition Based on Superheat Degree

Fully-Coupled Electric-Thermal-Flow Modeling and Investigation of Dynamic Thermal-Ledge Behavior in Aluminum Electrolysis Cell

Relationship Between Aluminium Electrolysis Current Efficiency and Operating Condition in Electrolyte Containing High Concentration of Li and K

Numerical Simulation of Alumina-Mixing Process with a Multicomponent Flow Model Coupled with Electromagnetic Forces in Aluminum Reduction Cells

Temperature prediction of aluminum reduction cell based on integration of dual attention LSTM for non-stationary sub-sequence and ARMA for stationary sub-sequences

Relationship between alumina mixing characteristics and feeder configurations in aluminum reduction cells

Numerical Simulation of Prebaked Anode Current and Temperature Fields of Aluminum Reduction Cell

An Inhomogeneous Three-Phase Model for the Flow in Aluminium Reduction Cells

Analysis of Alumina Concentration Control in Aluminum Electrolytic Bath

Quantitative Analysis of Complex Aluminum Electrolytes by X‐Ray Fluorescence