Abstract:To reduce the fuel consumption and emissions and also enhance the molten aluminum quality,a mathematical model with user-developed melting model and burning capacity model,were established according to the features of melting process of regenerative aluminum melting furnaces.Based on validating results by heat balance test for an aluminum melting furnace,CFD（computational fluid dynamics） technique,in association with statistical experimental design were used to optimize the melting process of the aluminum melting furnace.Four important factors influencing the melting time,such as horizontal angle between burners,height-to-radius ratio,natural gas mass flow and air preheated temperature,were identified by PLACKETT-BURMAN design.A steepest descent method was undertaken to determine the optimal regions of these factors.Response surface methodology with BOX-BEHNKEN design was adopted to further investigate the mutual interactions between these variables on RSD（relative standard deviation） of aluminum temperature,RSD of furnace temperature and melting time.Multiple-response optimization by desirability function approach was used to determine the optimum melting process parameters.The results indicate that the interaction between the height-to-radius ratio and horizontal angle between burners affects the response variables significantly.The predicted results show that the minimum RSD of aluminum temperature（12.13%）,RSD of furnace temperature（18.50%） and melting time（3.9 h） could be obtained under the optimum conditions of horizontal angle between burners as 64°,height-to-radius ratio as 0.3,natural gas mass flow as 599 m3/h,and air preheated temperature as 639 °C.These predicted values were further verified by validation experiments.The excellent correlation between the predicted and experimental values confirms the validity and practicability of this statistical optimum strategy.

Numerical Simulation and Combination Optimization of Aluminum Holding Furnace Linings Based on Simulated Annealing

Numerical Simulation and Optimizing Combination of Aluminum Melting Furnace Linings

Numerical Simulation of Melting Process for Regenerative Aluminum Melting Furnace

Numerical Simulation and Chaotic Analysis of an Aluminum Holding Furnace

Numerical Simulation of Aluminum Holding Furnace with Fluid-Solid Coupled Heat Transfer

Steel Ladle Slag Zone Lining Optimization Considering Irreversible Material Behavior

Furnace-Grouping Problem Modeling and Multi-Objective Optimization for Special Aluminum

Optimization and Simulation of Horizontal Angle between Burners in an Aluminum Melting Furnace

Mathematical Modelling for Furnace Design Refining Molten Aluminum

Thermomechanical behavior of alumina–magnesia castables and numerical modeling of the steel ladle thermal process

Numerical simulation of combustion and melting process in an aluminum melting Furnace: A study on optimizing stacking mode

Numerical modeling of the heat treatment with residual heat of aluminum castings

Numerical Simulation of Combustion and Fluid-solid Coupled Heat Transfer on the Aluminum Reverberatory Holding Furnace

Modeling approach and numerical analysis of a roller-hearth reheating furnace with radiant tubes and heating process optimization

Transient Multi-Field Coupled Simulation and Parameters Optimization of Cylindrical Regenerative Aluminum Melting Furnace

Numerical Simulation on Melt Flow with Bubble Stirring and Temperature Field in Aluminum Holding Furnace

Numerical Simulation On Direct Chilled Continuous Casting Process For Preparing Clad Slab Of Aluminium Alloys

Multiple-response Optimization for Melting Process of Aluminum Melting Furnace Based on Response Surface Methodology with Desirability Function

Mould Taper Optimization for Continuous Casting Steels by Numerical Simulation

Numerical Simulation and Parameter Optimization of the Emisolid Aluminumalloy Induction Reheating Process

Optimization of parameters for an aluminum melting furnace using the Taguchi approach