Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

3D-CFD Simulation of Liquid–Liquid Two-Phase Flow in A Pilot-Plant Scale Annular Pulsed Disc and Doughnut Column

CFD Simulation of Liquid–Liquid Two-Phase Hydrodynamics and Axial Dispersion Analysis for a Non-Pulsed Disc and Doughnut Solvent Extraction Column

Augmented CFD–PBM Simulation of Liquid–Liquid Two-Phase Flows in Liquid Extraction Columns with Wettable Internal Plates

Determining Axial Dispersion Coefficients of Pilot-Scale Annular Pulsed Disc and Doughnut Columns

Three-dimensional Computational Fluid Dynamics Modeling of Two-phase Flow in a Structured Packing Column

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Numerical Simulation and Analysis of Solid-Liquid Two-Phase Flow in Centrifugal Pump

CFD Simulation of Gas–Liquid–Liquid Three-Phase Flow in an Annular Centrifugal Contactor

Computational Fluid Dynamics Simulations on Two-Phase Flow Field of Gas Distributor in Packing Column

CFD Simulation of Flow and Mass Transfer in Structured Packing Distillation Columns

Portraying the Countercurrent Flow on Packings by Three‐Dimensional Computational Fluid Dynamics Simulations

Progress of Simulation of Fluid Flow Behavior in Structured Packed Column by Computational Fluid Dynamics

Numerical Simulation of Multiphase Flow in Combined Guided Valve Tray of Distillation Column

Numerical Simulation of Flowing Property in Hydrophobically Associating Polymer Dissolution Tank

CFD Simulations of the Air/Water Two-phase Flow in an Annular Centrifugal Contactor

Transient CFD Modelling of Air–Water Two-Phase Annular Flow Characteristics in a Small Horizontal Circular Pipe

CFD Simulation of Two-Phase Flow in a Hybrid Pulsed Sieve-Plate Solvent Extraction Column: Prediction of Holdup and Axial-dispersion Coefficients

CFD simulation of liquid flow characteristics in a rotor-stator spinning disc reactor

Scale-Up Study on the Performance of Annular Pulsed Disc-And-Doughnut Columns

CFD modeling of hydrodynamic characteristics of a gas-liquid two-phase stirred tank

Hydrodynamics and Mass-Transfer Characteristics Analysis of Vapor–liquid Flow of Dual-Flow Tray