Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Augmented CFD–PBM Simulation of Liquid–Liquid Two-Phase Flows in Liquid Extraction Columns with Wettable Internal Plates

CFD-PBM Investigation on Droplet Size Distribution in a Liquid–Liquid Stirred Tank: Effect of Impeller Type

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Combining Level-Set Method and Population Balance Model to Simulate Liquid–liquid Two-Phase Flows in Pulsed Columns

Evolution and Interaction Characteristics of Liquid Flow and Bubbles in a Jet Bubbling Column

Modelling of Mass Transfer for Gas-Liquid Two-Phase Flow in Bubble Column Reactor with a Bubble Breakage Model Considering Bubble-Induced Turbulence

3D-CFD Simulation of Liquid–Liquid Two-Phase Flow in A Pilot-Plant Scale Annular Pulsed Disc and Doughnut Column

CFD Simulation of Liquid–Liquid Two-Phase Hydrodynamics and Axial Dispersion Analysis for a Non-Pulsed Disc and Doughnut Solvent Extraction Column

CFD Simulation of Gas-Liquid Flow in Bubble Column with Two-bubble Phase Population Balance Model

Population Balance of Droplets in a Pulsed Disc and Doughnut Column with Wettable Internals

CFD–PBM simulation of two-phase flow in a pulsed disc and doughnut column with directly measured breakup kernel functions

CFD–PBM Simulation of Liquid–Liquid Dispersions in a Pump-Mixer

CFD-PBM Simulation of Sauter Mean Diameter in a Stirred Sieve-Plate Extraction Column

CFD Simulation of Two-Phase Flow in a Hybrid Pulsed Sieve-Plate Solvent Extraction Column: Prediction of Holdup and Axial-dispersion Coefficients

CFD-PBM Simulation of Droplets Size Distribution in Rotor-Stator Mixing Devices

A CFD‐PBM‐ANN framework to simulate the liquid–liquid two‐phase flow in a pulsed column

Key Parameter Prediction and Validation for a Pilot-Scale Rotating-Disk Contactor by CFD–PBM Simulation

Hydraulic Performance of an Annular Pulsed Disc-and-Doughnut Column

Drop Breakage in a Coalescence-Dispersion Pulsed-Sieve-plate Extraction Column

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

A Study on Liquid‐liquid Dispersions in a Continuous Mixer Via Computational Fluid Dynamics (CFD) Simulation Combined with Population Balance Model (PBM)