Study on the Flow Characteristics of Mixed Solid–Solid Particles

Peng Liang,Jia-Long Zhu,Ya-Qing Zhang,Xi-Zhuang Qin,Xue-Long Lv

DOI: https://doi.org/10.1252/jcej.16we327

2018-01-01

JOURNAL OF CHEMICAL ENGINEERING OF JAPAN

Abstract:We herein report the design of a two-dimensional cold moving bed with a wedge-shaped insert to investigate the effect of flow corrective insert on the flow characteristics of solid-solid mixture and further, to characterize the flow mechanism. The geometric dimensions and locations of the five types of wedge inserts used in this study were obtained using a reported method. Quartz sand and silica gel were selected as the solid experimental materials. The flow pattern, downward speed, and variation in local mixing ratios following complete mixing were explored. Six experimental conditions were established, and the mixing degrees along both the vertical and horizontal directions in the moving bed were measured. Fluctuation of the mixing degree was minimized when the insert half-angle theta(2), was 50 degrees, while at theta(2),= 20 degrees, the mixed materials above the insert shifted downward uniformly. The mixing ratio of quartz sand gradually decreased in the core flow region and increased in the transition region with increasing bed depth. In addition, as theta(2) decreased, the stagnant region within the insert became smaller, and the mixing ratio increased. These results demonstrate that the flow corrective insert can enhance the funnel flow as well as influence the flow separation of the solid solid mixture.