Abstract:The evolution of phase composition and mechanical properties and the formation of oxide layers on Fe40–xNiCoCrAlx (x = 5 and 10 at.%) alloys in long-term oxidation at 900 and 1000°C were studied. In the initial cast state, depending on the aluminum content and valence electron concentration, the alloys contain only an fcc solid solution (VEC = 8 e/a) or a mixture of fcc and bcc phases (VEC = = 7.75 e/a). Thin continuous oxide scales containing Cr2O3 and NiCr2O4 spinel formed on the surface of both alloys oxidized at 900°C for 50 h. A further increase in the annealing time to 100 h leads to the formation of aluminum oxide Al2O3 in the scale on the Fe30Ni25Co15Cr20Al10 alloy, having high protective properties. An increase in the oxidation temperature to 1000°C results in partial failure of the protective layer on the alloy with 10 at.% Al. Long-term holding at 900°C (100 h) + 1000°C (50 h) does not change the phase composition of the Fe35Ni25Co15Cr20Al5 alloy matrix, being indicative of its high thermal stability. In the two-phase Fe30Ni25Co15Cr20Al10 alloy, the quantitative ratio of solid solutions sharply changes: the amount of the bcc phase increases from 4 to 54 wt.% and its B2-type ordering is observed. The mechanical characteristics of the starting alloys and those after long-term high-temperature annealing were determined by automated indentation. The hardness (HIT) and elastic modulus (E) of the cast Fe35Ni25Co15Cr20Al5 alloy are equal to 2 and 147 GPa, respectively, and decrease to 1.8 and 106 GPa after a series of long-term annealing operations. The Fe30Ni25Co15Cr20Al10 alloy shows the opposite dependence: HIT increases from 2.5 in the initial state to 3.1 GPa after annealing and E decreases from 152 to 134 GPa. This indicates that the Fe30Ni25Co15Cr20Al10 alloy is promising as a high-temperature oxidation-resistant and creep-resistant material.

High Temperature Oxidation of Fe–Ni-base Alloy HR120 and Ni-base Alloy HAYNES 282 in Steam

Oxidation Behavior of a New Fe–Ni–Cr-based Alloy in Pure Steam at 750 °C

High Temperature Oxidation of Superalloys in Steam Environment

High Temperature Oxidation of Newly Developed Alloy 282 in the Flowing-Air and Steam Condition at 900–1100 °C

Oxide-Scale Evolution on a New Ni–Fe-Based Superalloy at High Temperature

Characterization of Oxide Scales on Super-Alloy HR120 at 1000 °C in Air and Steam Environments

High Temperature Oxidation Behavior of Ni-based High Entropy Superalloys

Oxidation Kinetics Of Haynes 230 Alloy In Air At Temperatures Between 650 And 850 Degrees C

Oxidation of a 4 wt.% Hf-containing nickel-based alloy at temperatures ranging from 1100°C to 1250°C in air

High Temperature Oxidation Behavior of Al0.5CrCoFeNi High Entropy Alloy

Oxidation behavior of high Hf nickel-based superalloy in air at 900, 1000 and 1100°C

Behaviors in Oxidation at 1100°C of an Equimolar CoNiFeMnCr High-Entropy Alloy and of its Versions Moderately Added with HfC or TaC Carbides

Structural State of High-Entropy Fe40–xNiCoCrAlx Alloys in High-Temperature Oxidation

A Novel NiCoCrAlPt High-Entropy Alloy with Superb Oxidation Resistance at 1200 °C

Corrosion Behavior of HAYNES 120 in High Temperature Simulated Ash Environment

Effect of Temperature on the Oxidation Mechanism of Ni-30Cr Alloy

The Influence of Temperature on the Oxidation Mechanism in Air of HR3C and Aluminum-Containing 22Cr–25Ni Austenitic Stainless Steels

High-temperature corrosion of Fe-Ni-based alloy HR6W, Ni-based alloys Haynes 282 and Inconel 740 in supercritical water at 450 °C and 25 MPa

Cyclic oxidation behaviour of as-deposited Ni-11·5Cr-4·5Co-0·5Al superalloy sheet when heated at 800°C

High Temperature Oxidation Behavior of the Wrought Ni-based Superalloy GH4037 in the Solid and Semi-Solid State

Short-time Oxidation of Alloy 690 in High-temperature and High-pressure Steam and Water