Abstract:The determining role of C- and Si-content on the shape memory effect of Fe–Mn–Si–Cr–Ni alloys, where Si was partly replaced by Co. In this regard, three alloys, Fe–15Mn–5Si–8Cr–5Ni, Fe–15Mn–5Si–8Cr–5Ni-0.1C, and Fe–15Mn–3Si–8Cr–5Ni-0.1C–2Co were designed to simultaneously study the shape memory effect and mechanical properties in relation to the microstructure. The microstructure of the alloys after cold rolling and annealing was analyzed by EBSD and X-ray diffraction techniques. The results indicated that grain size and the addition of C influenced the shape memory effect of Fe–Mn–Si–Cr–Ni-based memory alloy. With the increase of grain size, the annealing twin density was decreased, reducing the constraint on phase transformation of γ-austenite to ε-martensite. Furthermore, the austenite stability was decreased, such that the martensite-content was increased, and then reduced the shape memory effect of the experimental alloy. With the addition of C, the content of thermally-induced martensite was reduced, and the probability of stress-induced transformation of martensite to obtain α′-martensite was reduced, with consequent enhancement of the shape memory effect for the experimental steel. Additionally, the strength of parent phase was enhanced by the addition of C, and the plastic deformation by slip during stress-induced martensite was minimized, leading to low α′-martensite content and promotion of reversal of stress-induced martensite.

Microstructure characterization, stress–strain behavior, superelasticity and shape memory effect of Cu–Al–Mn–Cr shape memory alloys

Microstructure, superelasticity and shape memory effect by stress-induced martensite stabilization in Cu–Al–Mn–Ti shape memory alloys

Superelasticity and Shape Memory Effect in Cu–Al–Mn–V Shape Memory Alloys

Microstructure, Martensitic Transformation and Shape Memory Effect of Polycrystalline Cu-Al-Mn-Fe Alloys

Microstructure, Martensitic Transformation and Shape Memory Effect of Novel Cu–Al-Ga Based Shape Memory Single Crystals

Microstructure, Martensitic Transformation and Excellent Shape Memory Effect of Ga-alloyed Cu–Al–Mn–Fe Shape-Memory Single Crystal

Excellent Shape Recovery Characteristics of Cu-Al-Mn-Fe Shape Memory Single Crystal

Microstructure, Martensitic Transformation And Superelasticity Of T1(49) (6)N1(45 1)Cu(5)Cr(0 3) Shape Memory Alloy

The Improvement of the Shape Memory Effect of Cu-13.5Al–4Ni High-Temperature Shape Memory Alloys Through Cr-, Mo-, or V-alloying

Microstructure, Martensitic Transformation and Superelasticity of Ti49.6Ni45.1Cu5Cr0.3 Shape Memory Alloy

Shape Memory Effect Promoted Through Martensite Stabilization Induced by the Precipitates in Cu-Al-Mn-Fe Alloys

Excellent superelasticity and fatigue resistance of Cu-Al-Mn-W shape memory single crystal obtained only through annealing polycrystalline cast alloy

Microstructure and Mechanical Properties of Ti–V–Al–Cu Shape Memory Alloy by Tailoring Cu Content

A Novel Ni-alloyed Cu-Al-Ga-Fe Shape Memory Alloy with Excellent Shape Recovery Performance

Fe–Mn–Si–Cr–Ni Based Shape Memory Alloy: Thermal and Stress-Induced Martensite

Excellent Superelasticity of Cu-Al-Mn-Cr Shape Memory Single Crystal Obtained Only Through Annealing Cast Polycrystalline Alloy

Stress-Induced Microstructural Evolution of Martensite in Additive Manufactured Cu-13al-4mn Shape Memory Alloy

MICROSTRUCTURE AND PROPERTY OF Fe-15Mn-5Si-9Cr-5Ni-0.5Ti SHAPE MEMORY ALLOYS

Effect of Al content on thermal stability, shape memory effect and mechanical properties of Cu–Al–Fe shape memory alloys

A jumping shape memory alloy under heat

Study of Ni–Mn–Ga–Cu As Single-Phase Wide-Hysteresis Shape Memory Alloys