Abstract:The beneficial effect of the alkali metals such as Na and K on the Cu(In,Ga)Se-2 (CIGS) and Cu2ZnSn(S,Se)(4) (CZTSSe) solar cells has been extensively investigated in the past two decades, however, in most of the studies the alkali metals were treated as dopants. Several recent studies have showed that the alkali metals may not only act as dopants but also form secondary phases in the absorber layer or on the surfaces of the films. Using the first-principles calculations, we screened out the most probable secondary phases of Na and K in CIGS and CZTSSe, and studied their electronic structures and optical properties. We found that all these alkali chalcogenide compounds have larger band gaps and lower VBM levels than CIGS and CZTSSe, because the existence of strong p-d coupling in CIS and CZTS pushes the valence band maximum (VBM) level up and reduces the band-gaps, while there is no such p-d coupling in these alkali chalcogenides. This band alignment repels the photo-generated holes from the secondary phases and prevents the electron-hole recombination. Moreover, the study on the optical properties of the secondary phases showed that the absorption coefficients of these alkali chalcogenides are much lower than those of CIGS and CZTSSe in the energy range of 0-3.4eV, which means that the alkali chalcogenides may not influence the absorption of solar light. Since the alkali metal dopants can passivate the grain boundaries and increase the hole carrier concentration, and meanwhile their related secondary phases have innocuous effect on the optical absorption and band alignment, we can understand why the alkali metal dopants can improve the CIGS and CZTSSe solar cell performance. (C) 2017 Science Pressand Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. and Science Press. All rights reserved.

First-Principles GGA+U Study of Intermediate-Band Characters from Zn 1-X M X O（M=3d Transition-Metal）Alloys Suitable for High Efficiency Solar Cell

The Study of Electronic Structure and Absorption Coefficient of ZnTe:O Alloys: A GGA+U Method

A First-Principles Study On Electronic And Optical Properties For Zn31-Xalxmgo

First Principles Calculation Study of Zn1-xMgxO/Cu2ZnSnS4 Heterointerface

Theoretical Optoelectronic Analysis of Intermediate-Band Photovoltaic Material Based on Zny1-Xox (Y = S, Se, Te) Semiconductors by First-Principles Calculations

Band Engineering of Ni1−xMgxO Alloys for Photocathodes of High Efficiency Dye-Sensitized Solar Cells

Effect of Oxygen Implantation on Microstructural and Optical Properties of Znte:O Intermediate-Band Photovoltaic Materials

Low-Temperature Plasma-Enhanced Atomic Layer Deposition of ZnMgO for Efficient CZTS Solar Cells

Influences of Mg concentration in ZnMgO film on energy band alignment at CIGSSe/Zn1-xMgxO interface and performances of CIGSSe solar cells

Wide Range Bandgap Modulation Based on Zno-Based Alloys and Fabrication of Solar Blind Uv Detectors with High Rejection Ratio

First principles phase diagram and electronic structure estimation of ZnO1-xSex photoanodes

Cu2Zn(Sn,Ge)Se4and Cu2Zn(Sn,Si)Se

Improved Efficiency by Insertion of Zn1−xMgxO Through Sol-Gel Method in ZnO/Sb2Se3 Solar Cell

P-type conductive BaZrS3 thin film and its band gap tunning via Ruddlesden-Popper Ba3Zr2S7 and titanium alloying

Compositional Dependence of Structural and Electronic Properties of Cu2ZnSn(S,Se)4alloys for Thin Film Solar Cells

First-principles Study on the Alkali Chalcogenide Secondary Compounds in Cu(In,Ga)Se-2 and Cu2ZnSn(S,Se)(4) Thin Film Solar Cells

Structure and Optical Properties of AlxZn1−xO Alloys by Sol–gel Technique

Enhanced Visible Light Absorption in ZnO/GaN Heterostructured Nanofilms

Composition dependent band offsets of ZnO and its ternary alloys

First-principles study of mechanical and optical properties for ZnS<sub>1<i>-x</i></sub>O<i><sub>x</sub></i> alloying compounds

Synthesis of Conducting Zn1−xMgxO: Al Layers by Spray Pyrolysis for Photovoltaic Application