Abstract:Substitution of Zn with Mg has been reported to suppress CuZn defects, which can improve the photoelectric performance of Cu2ZnSn(S,Se)4 (CZTSSe) photovoltaic devices. In our work, the electrical property enhancement of an absorbing layer can be found by incorporating Mg content into the as-prepared precursor solution, forming an alloyed Cu2MgxZn1-xSn(S,Se)4 (CMZTSSe) phase and increasing the photoelectric performance of devices. By adjusting the doping ratio of Mg, we systemically study the impact of Mg content on the crystal structure, thickness, and electrical properties of the Cu2MgxZn1-xSn(S,Se)4 absorbing layer. Also, the photoelectric performance of Cu2MgxZn1-xSn(S,Se)4 solar cells have a large improvement, and the optimal photoelectric conversion efficiency (PCE) of 7.76% for devices is obtained. Our results offer the finding that Mg doping can optimize the electrical properties of Cu2ZnSn(S,Se)4 photovoltaic devices.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.0c02121?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.0c02121</a>.ICP-OES results of Cu2MgxZn1-xSn(S,Se)4 thin films, XPS spectra of Cu2Mg0.0714Zn0.9286Sn(S,Se)4 thin films, Raman spectra, surface roughness values, average surface current values, I–V curves, and diffuse reflection spectra of Cu2MgxZn1-xSn(S,Se)4 thin films (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.0c02121/suppl_file/ae0c02121_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Influences of Mg concentration in ZnMgO film on energy band alignment at CIGSSe/Zn1-xMgxO interface and performances of CIGSSe solar cells

Influence of Mg concentration in Zn1-Mg O buffer layers for enhanced Cu2(Sn,Ge)S3 solar cells performance

Preparation and Characterization of Mg-doped ZnO Thin Films by Sol–gel Method

Tuning the band gap of the CIGS solar buffer layer Cd1−xZnxS (x=0–1) to achieve high efficiency

Energy Band Alignment at p-n Heterojunction Interface in CZTSSe Solar Cells with Novel ZnMgO Buffer Layer

Characterizing ZnMgO/Sb2Se3 Interface for Solar Cell Applications

Boosting the Electrical Properties of Cu 2 ZnSn(S,Se) 4 Solar Cells via Low Amounts of Mg Substituting Zn

CdS(In)/CZTSSe bandgap alignment engineering for performance enhancement of solar cells without ZnO layer

Study on the Performance of Oxygen-Rich Zn(O,S) Buffers Fabricated by Sputtering Deposition and Zn(O,S)/Cu(In,Ga)(S,Se) 2 Interfaces

Influence of Cd0.6Zn0.4S buffer layer on the band alignment and the performance of CZTS thin film solar cells

Doping Behavior of Zn in CdS and Its Effect on the Power Conversion Efficiency of the Cu2ZnSn(S, Se)4 Solar Cell

Enhancement of Cd-Free All-Dry-Processed Cu(In1-x,Gax)Se2 Thin-Film Solar Cells by Simultaneous Adoption of an Enlarged Bandgap Absorber and Tunable Bandgap Zn1-xMgxO Buffer

Photovoltaic performance in CIGS solar cells: effects of using Mg- and Al-doped ZnO thin-film layers as alternative TCO and front contact layer

Enhancing the properties of Cd-free MgZnS buffer for solar cells by co-sputtering ZnS and Mg targets

Electrical barriers and their elimination by tuning (Zn,Mg)O composition in Cu(In,Ga)S2: Systematic approach to achieve over 14% power conversion efficiency

Effects of annealing temperature and atmosphere on performances of Zn0.9Mg0.1O buffer layers for CIGS solar cell

Effect of Magnesium Incorporation on Solution-Processed Kesterite Solar Cells

Atomic-Scale Interface Modification Improves the Performance of Cu(In1- xGax)Se2/Zn(O,S) Heterojunction Solar Cells

Optimizing the Band Alignment of the MZO/CdSeTe/CdTe Solar Cell by Varying the Substrate Temperature of MZO Film

Improvement of the CIGS solar cell performance: structure based on a ZnS buffer layer

Growth of Zn doped Cu(In, Ga)Se 2 thin films by RF sputtering for solar cell applications