Abstract:(0.95-x) BaTiO3-0.05 BiYbO3-x BiFeO3 (x = 0, 0.01, 0.02, and 0.04) (abbreviated as (0.95-x) BT-0.05 BY-x BFO) ceramics were fabricated by conventional sintering (CS) and microwave sintering (WS) methods. Effects of sintering method and BFO dopant on the microstructure and electric properties of (0.95-x) BT-0.05 BY-x BFO ceramics were comparatively investigated. X-ray diffraction showed that all CS and WS samples presented a single perovskite phase. It was also found that WS ceramics possessed denser microstructure and finer grains compared to CS samples as indicated by the surface morphology characterization. Dielectric measurements revealed that all samples exhibited the weak relaxation behavior; however, the degree of relaxation behavior of BT-BY based ceramic could be strengthened by addition of BFO and by WS method. Moreover, the temperature and frequency stability could be improved with doped BFO. The density of 0.93BT-0.05BY-0.02BFO ceramic was found to be the largest while that of 0.94BT-0.05BY-0.01BFO ceramic was the smallest, thus, the dielectric constant of 0.93BT-0.05BY-0.02BFO was significantly larger than that of 0.94BT-0.05BY-0.01BFO and 0.94BT-0.05BY-0.04 BFO ceramics. minimum dielectric constant of (0.95-x) BT-0.05 BY-x BFO ceramic was obtained at x = 0.01. Ferroelectric measurements indicated that all samples showed the slim hysteresis loop. The remnant polarization (P-r) and coercive field (E-C) of (0.95-x) BT-0.05 BY-x BFO ceramics first decreased and then increased with increasing x, the minimum values were obtained at x = 0.01. Moreover, P-r and E-C of WS ceramics were slightly larger than those of CS ceramics, indicating that higher density and larger grain sizes contributed to enhancing the ferroelectric characteristic. These findings indicate that addition of moderate amount of BFO and use of WS technique can strengthen the degree of relaxation behavior and improve the ferroelectric properties of BT-BY based ceramics.

Sol-Gel Synthesis and Characterization of (1–X–y)biybo3-Xlinbo3-ybatio3 Ceramics

Study on the Structure and Properties of (1-X) Biybo3-Xbatio(3) Ceramics Synthesized by Sol-Gel Method

Preparation and Characterization on Piezo-/Ferro-electric Properties Of(1-X)(knn+lt)+xbi Ceramics

Study on Microstructure and Properties of BiYbO3-BaTiO3-LiNbO3 Ceramics

Effects of Sintering Method and BiFeO3 Dopant on the Dielectric and Ferroelectric Properties of BaTiO3–BiYbO3 Based Solid Solution Ceramics

Microstructure, Dielectric and Ferroelectric Properties of (1−x) BaTiO3–xBiYbO3 Ceramics Fabricated by Conventional and Microwave Sintering Methods

Dielectric Properties and Defect Mechanisms of (1-X)ba(fe0.5nb0.5)o-3 -Xbiybo(3) Ceramics

Composition Design and Electrical Properties in (1-Y)(k0.40na0.60)0.985li0.015(nb1−xsbx)o3-ybi0.5na0.5zro3 Lead-Free Ceramics

Dielectric, ferroelectric, piezoelectric properties, and conduction behavior of (Bi0.5Na0.5)0.94+xBa0.06TiO3 ceramics

Synthesis of Bi4-xyxTi3O12 nanppowders by a sol-gel process

Improved dielectric temperature stability and energy storage properties of BNT-BKT-based lead-free ceramics

Phase/domain Structure and Enhanced Thermal Stable Ferro-/Pyroelectric Properties of (1-X)0.94na0.48 Bi0.44TiO3-0.06BaTiO3:xZnO Ceramics

Structural, Dielectric, Ferroelectric, and Magnetic Properties of Lead-Free (1-X)bife0.95ga0.03mn0.02o3−xbatio3 Ceramics

Synthesis of Bi4-xYxTi3O12 Nanopowders by a Sol-Gel Process

Effects of glass additives on microstructure, dielectric and ferroelectric properties of BaTiO3-BiYbO3 based ceramics

Structure and Dielectric Properties of BaTiO 3 -BiYO 3 Perovskite Solid Solutions

Electrical properties of (1-x)BiFe0.94Zn0.03Ti0.03O3-xBaTiO3 lead-free ceramics obtained via sol-gel route and two-step sintering process

Effect of Dy2O3 on the Structure and Electrical Properties of (bi0.5na0.5)0.94ba0.06tio3 Lead-Free Piezoelectric Ceramics

Structural, Piezoelectric, Multiferroic and Magnetoelectric Properties of (1-X)bifeo3-xba1-ysry TiO3solid Solutions

Enhanced Energy Storage Properties of BaTiO3-Bi0.5Na0.5TiO3 Lead-Free Ceramics Modified by SrY0.5Nb0.5O3

Preparation and Electrical Properties of (1−x)(na0.5bi0.5)tio3–xbialo3 Thin Films by a Sol–gel Process