Abstract:Optical fiber X-ray sensors are prone to over-response compared to ionization chambers (ICs) when used to measure the percentage depth dose (PDD) curves and off axis ratio (OAR) curves. Investigating this phenomenon is crucial for the successful adoption of these sensors in clinical radiotherapy. Compared with ion chambers and other water equivalent dosimeters, the fiber X-ray sensors using high Zeff scintillators (Gd2O2S:Tb) have generally higher mass attenuation coefficients. In this case, the response of scintillators to photons needs to be considered. In this article, a Monte-Carlo (MC) software package BEAMnrc was used to simulate the distribution of photon and electron fluxes in a clinical based water phantom, besides the energy deposition of air and Gd2O2S:Tb in varying energy was also simulated. The distribution of the photon and electron fluxes in the horizontal (radial) direction at a fixed 10 cm water depth was studied, as well as the fluxes in the vertical (depth) direction. An embedded-structure fiber X-ray sensor was used for the experimental measurements. The simulation results indicate that, in the horizontal direction, there are many photons remain outside the radiation field. In the vertical direction, as the size of the radiation field increases, the maximum point of the photon flux shifts towards a deeper water depth. These behavior of photon flux is consistent with the fiber X-ray sensors measurement. However, the maximum point of the electron flux remains unchanged in the vertical direction. In the horizontal direction, the electron flux decreases rapidly, and this scenario is similar to the case when using the ion chamber. Results of analyzing the spectra inside and outside the radiation field show that there is a large number of photons with energy below 0.2 MeV outside the radiation field, and the proportion of these low-energy photons is greater than 60%. The findings indicate that the fiber X-ray sensors' over-response can be primarily attributed to the lower energy scattered photons.

Characters of γ-ray irradiated scintillation optical fiber by simulation based on Monte Carlo method

Loss Measurement for SCF Materials

Relationship Between Energy Deposited Efficiency and Γ-Ray Energy or Length of Scintillation Optical Fiber Based on Geant4 System

Simulation Study of Energy Absorption of X- and $\Gamma$-Rays in Plastic Scintillating Fiber Arrays

A Simulation Study on the Flash X-Ray Spectra Spatial Distribution

Monte Carlo simulation for transmission of photon in scintillation crystal

Numerical Simulation of Radial and Angular Distribution of Γ-Ray's Energy Deposition in Scintillation Optical Fibre

Calculation of Light Power Coupled from a Cylindrical Scintillator into Optical Fiber Using Monte Carlo Ray Tracing Method

Monte-Carlo Simulation for Determining SNR and DQE of Linear Array Plastic Scintillating Fiber

Simulation study on detection efficiency of plastic scintillating fiber under γ-ray radiation

Sensitivity of plastic scintillating fiber optic for X and γ radiation, a simulation study

Analysis of angular and radial distributions of gamma's energy deposition in scintillation optical fiber based on GEANT3 system

GEANT4 simulation study of over-response phenomenon of fiber x-ray sensor*

A Simulation Study of the DQE of a Linear Plastic Scintillating Fiber Array for Hard Gamma-Rays

Simulation on Fluorescence Characteristics of Square Scintillating Fiber Array

An Experimental and Theoretical Study of the Influence of Cerenkov Radiation on Optical Fiber X-ray Sensors

Quantitative Measurement of Γ-Ray and E-Beam Effects on Fiber Rayleigh Scattering Coefficient

Effect of Photons and Electrons on the Over-Response of Optical Fiber X-ray Sensors

Numerical Simulation of High Energy Neutron Radiography

Comparative Investigation of Gamma Radiation Effects on Long Period Gratings and Optical Power in Different Optical Fibers

Possibility Analysis about Imaging Using Plastic Scintillating Fiber Array for High-Energy Incident Beam