Abstract:A new scintillating fiber detector inside magnetic shielding tube was designed and assembled for use in the next round of fusion experiments in the experimental advanced superconducting tokamak to provide D-T neutron yield with time resolution. In this study, Geant4 simulations were used to obtain the pulse height spectra for ideal signals produced when detecting neutrons and gamma rays of multiple energies. One of the main sources of interference was found to be low-energy neutrons below 10-5 MeV, which can generate numerous secondary particles in the detector components, such as the magnetic shielding tube, leading to high-amplitude output signals. To address this issue, a compact thermal neutron shield containing a 1-mm Cd layer outside the magnetic shielding tube and a 5-mm inner Pb layer was specifically designed. Adverse effects on the measurement of fast neutrons and the shielding effect on gamma rays were considered. This can suppress the height of the signals caused by thermal neutrons to a level below the height corresponding to neutrons above 4 MeV because the yield of the latter is used for detector calibration. In addition, the detector has relatively flat sensitivity curves in the fast neutron region, with the intrinsic detection efficiencies (IDEs) of approximately 40%. For gamma rays with energies that are not too high (< 8 MeV), the IDEs of the detector are only approximately 20%, whereas for gamma rays below 1 MeV, the response curve cuts off earlier in the low-energy region, which is beneficial for avoiding counting saturation and signal accumulation.

Relationship Between Energy Deposited Efficiency and Γ-Ray Energy or Length of Scintillation Optical Fiber Based on Geant4 System

Numerical Simulation of Radial and Angular Distribution of Γ-Ray's Energy Deposition in Scintillation Optical Fibre

Analysis of angular and radial distributions of gamma's energy deposition in scintillation optical fiber based on GEANT3 system

Characters of γ-ray irradiated scintillation optical fiber by simulation based on Monte Carlo method

A Simulation Study on the Flash X-Ray Spectra Spatial Distribution

Simulation study on detection efficiency of plastic scintillating fiber under γ-ray radiation

Simulation Study of Energy Absorption of X- and $\Gamma$-Rays in Plastic Scintillating Fiber Arrays

Spatial Distribution Characteristics of High-energy Flash X-ray Energy Spectrum

Sensitivity of plastic scintillating fiber optic for X and γ radiation, a simulation study

GEANT4 simulation study of over-response phenomenon of fiber x-ray sensor*

Quantitative Measurement of Γ-Ray and E-Beam Effects on Fiber Rayleigh Scattering Coefficient

Monte-Carlo Simulation for Determining SNR and DQE of Linear Array Plastic Scintillating Fiber

Study on the Gamma-Rays and Neutrons Energy Response Optimization of a Scintillating Fiber Detector for EAST with Geant4

Influence of various geometries on detection efficiency of polystyrene, polyvinyl-toluene, and sodium iodide detectors using Geant4

A Simulation Study of the DQE of a Linear Plastic Scintillating Fiber Array for Hard Gamma-Rays

Effect of Steady-state and Transient Γ Radiation on Ge-doped Quartz Optical Fiber

Possibility Analysis about Imaging Using Plastic Scintillating Fiber Array for High-Energy Incident Beam

Comparative Investigation of Gamma Radiation Effects on Long Period Gratings and Optical Power in Different Optical Fibers

Fiber-Coupling Efficiency of Gaussian Schell Model for Optical Communication Through Atmospheric Turbulence

Erasure Effect Of The Reading Beam On The Decay Process Of Chi((2)) In All-Optical Poling

Numerical Simulation of High Energy Neutron Radiography