Abstract:Spatially resolved spectroscopy provides a means for measuring the optical properties of biological tissues, based on analytical solutions to diffusion approximation for semi-infinite media under the normal illumination of an infinitely small light beam. The method is, however, prone to error in measurement because the actual boundary condition and light beam often deviate from that used in deriving the analytical solutions. It is therefore important to quantify the effect of different boundary conditions and light beams on spatially resolved diffuse reflectance in order to improve the measurement accuracy of the technique. This research was aimed at using finite element method (FEM) to model light propagation in turbid media, subjected to normal illumination by a continuous-wave beam of infinitely small or finite size. Three types of boundary conditions [i.e., partial current (PCBC), extrapolated (EBC), and zero (ZBC)] were evaluated and compared against Monte Carlo (MC) simulations, since MC could provide accurate fluence rate and diffuse reflectance. The effect of beam size was also investigated. Overall results showed that FEM provided results as accurate as those of the analytical method when an appropriate boundary condition was applied. ZBC did not give satisfactory results in most cases. FEM-PCBC yielded a better fluence rate at the boundary than did FEM-EBC, while they were almost identical in predicting diffuse reflectance. Results further showed that FEM coupled with EBC effectively simulated spatially resolved diffuse reflectance under the illumination of a finite size beam. A large beam introduced more error, especially within the region of illumination. Research also confirmed an earlier finding that a light beam of less than 1 mm diameter should be used for estimation of optical parameters. FEM is effective for modeling light propagation in biological tissues and can be used for improving the optical property measurement by the spatially resolved technique. (C) 2015 Optical Society of America

Calculation of Light Power Coupled from a Cylindrical Scintillator into Optical Fiber Using Monte Carlo Ray Tracing Method

Analysis of flash lamp structure using Monte Carlo photon tracing method

Analysis of Structure Design of Flashlight Using Monte Carlo Photon Tracing Method

Coupled Optical and Electronic Simulations of Electrically Pumped Photonic-Crystal-Based Leds

Accurate Optical Optimization of Light-Emitting Diodes with Consideration of Coupling Between Purcell Factor and Transmittance Coefficient

Finite element modeling of light propagation in turbid media under illumination of a continuous-wave beam

Comparative Study of NaI,BGO,LSO,GSO and YSO Scintillators Using Monte Carlo Simulations

Monte Carlo simulation for transmission of photon in scintillation crystal

Stray Light Analysis And Calculation Modeling Of Optical System

Analysis of Power Transfer Characteristics Among Many Parallel Optical Fibers

A mathematical model of the single freeform surface design for collimated beam shaping.

Modeling and stimulation of high-power double-clad fiber collimator

Modeling of Light Coupling Effect Using Tunneling Theory Based on Particle Properties of Light

Monte-Carlo simulation on the time performance of light transmission of the integrating sphere

Theoretical simulation and analysis of large size BMP-LSC by 3D Monte Carlo ray tracing model

Modelling of polymer optical fiber-based solar concentrators

Modeling and Optimization of Luminescent Solar Concentrator for Micro Cell Array Module

Collectible Optical Power of Various Specially Shaped Multimode Optical Fiber Probes for Contact Sensing

Directional light outcoupling enhancement of scintillators via hollow microlens arrays

Research on the PSF of Scintillators Asγ/fluorescence Image Converters

Taper-Microsphere Coupling with Numerical Calculation of Coupled-Mode Theory