Abstract:Spatially resolved spectroscopy provides a means for measuring the optical properties of biological tissues, based on analytical solutions to diffusion approximation for semi-infinite media under the normal illumination of an infinitely small light beam. The method is, however, prone to error in measurement because the actual boundary condition and light beam often deviate from that used in deriving the analytical solutions. It is therefore important to quantify the effect of different boundary conditions and light beams on spatially resolved diffuse reflectance in order to improve the measurement accuracy of the technique. This research was aimed at using finite element method (FEM) to model light propagation in turbid media, subjected to normal illumination by a continuous-wave beam of infinitely small or finite size. Three types of boundary conditions [i.e., partial current (PCBC), extrapolated (EBC), and zero (ZBC)] were evaluated and compared against Monte Carlo (MC) simulations, since MC could provide accurate fluence rate and diffuse reflectance. The effect of beam size was also investigated. Overall results showed that FEM provided results as accurate as those of the analytical method when an appropriate boundary condition was applied. ZBC did not give satisfactory results in most cases. FEM-PCBC yielded a better fluence rate at the boundary than did FEM-EBC, while they were almost identical in predicting diffuse reflectance. Results further showed that FEM coupled with EBC effectively simulated spatially resolved diffuse reflectance under the illumination of a finite size beam. A large beam introduced more error, especially within the region of illumination. Research also confirmed an earlier finding that a light beam of less than 1 mm diameter should be used for estimation of optical parameters. FEM is effective for modeling light propagation in biological tissues and can be used for improving the optical property measurement by the spatially resolved technique. (C) 2015 Optical Society of America

Monte-Carlo simulation on the time performance of light transmission of the integrating sphere

Monte-Carlo Simulation on the Performance of Light Power Waveform Transformation by the Integrating Sphere

Simulation of the output irradiance of integrating sphere with Monte Carlo method

Analysis of flash lamp structure using Monte Carlo photon tracing method

Finite element modeling of light propagation in turbid media under illumination of a continuous-wave beam

Measurement of Led Spatial Intensity Distribution Using Imaging

Spectrum measurement for LED-based spectrum-tunable source

Characterization of the Optical Properties of Photoluminescent Turbid Media Using an Integrating Sphere and Monte Carlo Simulations

Monte Carlo simulation for transmission of photon in scintillation crystal

Pulse Transmission Simulation in the Systems Including Diffraction Components by Real Ray Trace

Tailoring High-Performance Illumination Lenses for Extended Non-Lambertian Sources.

Numerical Investigation of Measurement Error of the Integrating Sphere Based on the Monte-Carlo Method

Study on Methodology of LED's Luminous Flux Measurement with Integrating Sphere

Simple Analytical Model for Optimizing Integrating Sphere Port Sizes

Effect of Light Source Uniformity for Imaging Ellipsometry Measurements

Calculation of Light Power Coupled from a Cylindrical Scintillator into Optical Fiber Using Monte Carlo Ray Tracing Method

Simulation Analysis of the Photographic Noncoincidence Between Fiber Ends and Light Spots under Integrating Sphere Light Source

Adjustable Illuminance Diffusion Calibration Light Source Produced with Integrating Sphere

Study on Transmission Non-uniformity of the Wide Field-of-View Optics

Study on a Spectrophotometer System for Measuring LED's Photometric Parameters

Numerical simulation of scintillant decay constant effect on radiation source boundary measurment