Abstract:Optical fiber X-ray sensors are prone to over-response compared to ionization chambers (ICs) when used to measure the percentage depth dose (PDD) curves and off axis ratio (OAR) curves. Investigating this phenomenon is crucial for the successful adoption of these sensors in clinical radiotherapy. Compared with ion chambers and other water equivalent dosimeters, the fiber X-ray sensors using high Zeff scintillators (Gd2O2S:Tb) have generally higher mass attenuation coefficients. In this case, the response of scintillators to photons needs to be considered. In this article, a Monte-Carlo (MC) software package BEAMnrc was used to simulate the distribution of photon and electron fluxes in a clinical based water phantom, besides the energy deposition of air and Gd2O2S:Tb in varying energy was also simulated. The distribution of the photon and electron fluxes in the horizontal (radial) direction at a fixed 10 cm water depth was studied, as well as the fluxes in the vertical (depth) direction. An embedded-structure fiber X-ray sensor was used for the experimental measurements. The simulation results indicate that, in the horizontal direction, there are many photons remain outside the radiation field. In the vertical direction, as the size of the radiation field increases, the maximum point of the photon flux shifts towards a deeper water depth. These behavior of photon flux is consistent with the fiber X-ray sensors measurement. However, the maximum point of the electron flux remains unchanged in the vertical direction. In the horizontal direction, the electron flux decreases rapidly, and this scenario is similar to the case when using the ion chamber. Results of analyzing the spectra inside and outside the radiation field show that there is a large number of photons with energy below 0.2 MeV outside the radiation field, and the proportion of these low-energy photons is greater than 60%. The findings indicate that the fiber X-ray sensors' over-response can be primarily attributed to the lower energy scattered photons.

An Experimental and Theoretical Study of the Influence of Cerenkov Radiation on Optical Fiber X-ray Sensors

Effect of Photons and Electrons on the Over-Response of Optical Fiber X-ray Sensors

New model for explaining the over-response phenomenon in percentage of depth dose curve measured using inorganic scintillating materials for optical fiber radiation sensors.

Experimental study of radiation dose detection based on plastic scintillating fiber

Recent Advances in Optical Fiber Enabled Radiation Sensors

GEANT4 simulation study of over-response phenomenon of fiber x-ray sensor*

Research on low-dose-rate and long distance radiation detection based on scintillating fibers

Radiation-induced attenuation effect on special optical fibers applied in space

Numerical Analysis of Radiation Effects on Fiber Optic Sensors

Radiation Distribution Sensor with Optical Fibers for High Radiation Fields

Radiation Damage Mechanisms and Research Status of Radiation-Resistant Optical Fibers: A Review

Effect of irradiation on temperature performance of dispersion-compensation no-core cascade optical-fiber sensor coated with polydimethylsiloxane film

Investigation of Radiation Effect on Single-Mode Fiber for Distributed Radiation Sensing Application

Research on Total Radiation Dose Detector Based on Fiber Induced Loss

Radiation Monitoring with Radiosensitive Pure-Silica Core Ultra-Low Loss Optical Fiber

Passive Optical Fiber Sensor Based on Cerenkov Effect

A Model of a Distributed Calorimetric Fiber Dosimeter Based on Stimulated Brillouin Scattering

Sensitivity of plastic scintillating fiber optic for X and γ radiation, a simulation study

Fiber-Coupled GAGG_Ce X-ray Detector for High-Resolution Imaging

Experimental Study of Distributed Optical Fiber Sensor for Crack Detection

Numerical and experimental study of radiation induced conductivity change of carbon nanotube filled polymers.