Preparation Of Nickel Foam Supported Fe2o3@Ni3s2 Nanowires Network Electrode And Electrocatalytic Oxygen Evolution Performance
Qiao Qing-Shan,Zhang Sheng,Zhou Xiao-Ya,Hu Li-Bing,Lu Hong-Bin,Tang Shao-Chun
DOI: https://doi.org/10.11862/CJIC.2021.162
2021-01-01
Chinese journal of inorganic chemistry
Abstract:A two-step hydrothermal method was used to prepare nickel foam (NF) supported Fe2O3 nanoparticles@Ni3S2 nanowires 3D network electrode (Fe2O3@Ni3S2/NF). The crystal phase and microstructure features of the products were characterized in detail by using some characterization techniques including X-ray diffraction(XRD), X-ray photoelectron spectroscopy (XPS), transmission electron microscopy (TEM), and N-2 adsorption-desorption measurement and so on. The in situ surface chemical etching process under hydrothermal conditions leads to the generation of Ni3S2 nanowires 3D network that binds to NF firmly with relatively low interfacial resistances. In an aqueous electrolyte of 1 mol.L-1 KOH, the electrocatalytic oxygen evolution reaction (OER) performance of the obtained electrodes was tested by linear sweep voltammetry (LSV), chronopotentiometry, and electrochemical impedance test (EIS). At a ultrathigh current density of 100 mA.cm(-2), Fe2O3@Ni3S2/NF electrode showed a low OER overpotential of only 223 mV, which was 285 mV lower than that of Ni3S2/NF electrode (before growth of Fe2O3). These excellent properties are attributed to the faster reaction kinetics and smaller charge transfer impedance of Fe2O3@Ni3S2/NF electrode comparing with Ni3S2/NF.