Abstract:A novel Rayleigh Doppler lidar technology based on a quadruple dual-pass Fabry–Perot interferometer (FPI) that can accurately measure wind field, temperature and aerosol backscatter ratio from the troposphere to lower stratosphere is proposed. This study aims to analyse the detection principle of wind speed, temperature and aerosol backscatter ratio in detail and obtain their measurement error formulas. The structure of this type of lidar is studied and designed. The FPI consists of two edge channels FPI-1 and FPI-2, aerosol channel FPI-M and locking channel FPI-L. FPI-1, FPI-2 and FPI-M use a dual-pass optical path, whereas FPI-L uses a single-pass optical path. The parameters of FPI are optimised as follows: the free spectral spacing (FSR) is 12 GHz, the FWHM of FPI-1 and FPI-2 are both 2.2 GHz, the peak-to-peak interval of FPI-1 and FPI-2 is 5.8 GHz, the FWHM of FPI-M and FPI-L are both 1.2 GHz, the peak-to-peak interval of FPI-M and FPI-1 is 2.9 GHz and the peak-to-peak interval of FPI-L and FPI-1 is 2.3 GHz. Under simulated atmospheric conditions, for a daytime sky background brightness of 0.3 Wsr −1 m −2 nm −1 at 355 nm, using a laser with a pulse energy of 350 mJ and a repetition frequency of 50 Hz and a telescope with a 0.45-m aperture, with a vertical range resolution of 30 m at 0–10 km, 100 m at 10–20 km and 500 m at 20–35km, temporal resolution of 30 min, zenith angle of 0° for temperature and aerosol backscatter ratio detection and temporal resolution of 3 min and zenith angle of 30° for radial wind speed detection, the detection performance of the designed Rayleigh Doppler lidar is determined. The simulation results show that the measurement errors of aerosol backscatter ratio, temperature and radial wind speed of the lidar system in the daytime and night-time are less than 4.36 × 10 −3 and 3.32 × 10 −3 (excluding cirrus cloud area), 4.0 K and 3.0 K and 3.8 m/s and 1.9 m/s, respectively, from an altitude of 0.06 to 35km.

Wind Profiling from High Troposphere to Low Stratosphere Using a Scanning Rayleigh Doppler Lidar

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI

Mobile Rayleigh Doppler lidar for wind and temperature measurements in the stratosphere and lower mesosphere

A Rotary Platform Mounted Doppler Lidar for Wind Measurements in Upper Troposphere and Stratosphere

Mid-altitude wind measurements with mobile Rayleigh Doppler lidar incorporating system-level optical frequency control method

Stratospheric Temperature Measurement with Scanning Fabry-Perot Interferometer for Wind Retrieval from Mobile Rayleigh Doppler Lidar

60 Km Rayleigh Doppler Lidar and Wind Measurement

Stratosphere wind and temperature measurements using a Rayleigh Doppler lidar in mid-latitude area of China

Low-altitude atmospheric wind measurement from the combined Mie and Rayleigh backscattering by Doppler lidar with an iodine filter

Mobile Rayleigh Doppler Wind Lidar Based on Double-Edge Technique

Performance of Continuous-wave Coherent Doppler Lidar for Wind Measurement

Low tropospheric wind profile from a 1.06 μm Doppler lidar

Ultraviolet trifrequency Rayleigh DWL for stratosphere atmospheric wind measurements during the daytime based on an ultranarrow-bandwidth optical receiver

Design and performance simulation of 532 nm Rayleigh–Mie Doppler lidar system for 5–50 km wind measurement

Development of 60 Km Mobile Rayleigh Wind Lidar

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Doppler Wind Lidar Based on Fabry-Perot Etalon

Direct Detection Doppler Wind Lidar Based on Dual FP Etalon

Remote Polar Boundary Layer Wind Profiling Using an All-Fiber Pulsed Coherent Doppler Lidar at Zhongshan Station, Antarctica

Validation of airborne 1 . 5 μ m all-fiber coherent lidar measurement of wind profiles