Abstract:Rayleigh Doppler lidar based on a quad Fabry-Perot etalon (FPE) is proposed that is capable of accurately detecting wind speed, as well as temperature and aerosol from 0.2 to 60km altitude. The structure of lidar is designed and its measurement principle is analyzed. One of the four FPEs, i.e. FPE-L is used for locking and measuring the outgoing laser frequency, and the other three, i.e. FPE-1, -2 and -3 form a three-stage FPE. The first-stage FPE (FPE-1) can effectively filter out Mie backscattering signal, thereby suppressing its effects on wind measurement and measuring the aerosol backscatter ratio as well. The transmission spectra of the second- and third-stage FPEs (FPE-2,-3) form double edge for simultaneous wind and temperature measurements by using Rayleigh backscattering signal. The parameters of the quad FPE are optimized. The FWHM and relative peak position of FPE-1,-2,-3,-L are 0.6, 1.2, 1.2, 0.6GHz and 0, -1, 1, 0.3GHz, respectively. The performance of the proposed lidar is simulated and results show that for 0.3WSr-1m-2nm-1@355nm sky brightness, by using a 350mJ pulse energy, 50Hz repetition frequency laser and a 0.8m aperture telescope, with temporal resolution of ∼20km, ∼60km and vertical resolution of ∼10km, ∼ 20km, ∼40km, ∼60km, the measurement errors of temperature, aerosol backscattering ratio and vertical wind speed are below 5.3K, 3.0×10-3, 1.1m/s in nighttime and below 14.6K, 8.1×10-3, 2.5m/s in daytime from 0.2 to 60km altitude; the measurement error of two other orthogonal LOS wind speed with fixed zenith angle of 25.8° is below 1.3m/s in nighttime and 3.5m/s in daytime within the LOS wind speed dynamic range of ±50m/s from 0.2 to 60km altitude.

Development of 60 Km Mobile Rayleigh Wind Lidar

60 Km Rayleigh Doppler Lidar and Wind Measurement

Mobile Rayleigh Doppler lidar for wind and temperature measurements in the stratosphere and lower mesosphere

Mid-altitude wind measurements with mobile Rayleigh Doppler lidar incorporating system-level optical frequency control method

Mobile Rayleigh Doppler Wind Lidar Based on Double-Edge Technique

Wind Profiling from High Troposphere to Low Stratosphere Using a Scanning Rayleigh Doppler Lidar

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Analysis of Detectors and Transmission Curve Correction of Mobile Rayleigh Doppler Wind Lidar

Development and Experimental Testing of a Rotary Direct Wind Lidar System Based on Fabry.Perot Interferometer Technology-=SUP=-*-=/SUP=-

Rayleigh-Mie Wind Lidar Based on Fabry-Perot Interferometer

Calibration of FP Etalon Transmittance Curve and Wind Field Observation Based on Doppler Wind Measurement Lidar

Design and performance simulation of 532 nm Rayleigh–Mie Doppler lidar system for 5–50 km wind measurement

A Rotary Platform Mounted Doppler Lidar for Wind Measurements in Upper Troposphere and Stratosphere

Design and Simulation of 532nm Rayleigh-Mie Doppler Wind Lidar System

Performance of Continuous-wave Coherent Doppler Lidar for Wind Measurement

1.55Μm All-Fiber Coherent Doppler Lidar for Wind Measurement

Demonstration of Daytime Wind Measurement by Using Mobile Rayleigh Doppler Lidar Incorporating Cascaded Fabry-Perot Etalons

1.55-Μm Pulse Coherent LIDAR with 10-Km Detection Range

Stratospheric Temperature Measurement with Scanning Fabry-Perot Interferometer for Wind Retrieval from Mobile Rayleigh Doppler Lidar

Doppler Wind Lidar Based on Fabry-Perot Etalon

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI