Abstract:Rayleigh Doppler lidar based on a quad Fabry-Perot etalon (FPE) is proposed that is capable of accurately detecting wind speed, as well as temperature and aerosol from 0.2 to 60km altitude. The structure of lidar is designed and its measurement principle is analyzed. One of the four FPEs, i.e. FPE-L is used for locking and measuring the outgoing laser frequency, and the other three, i.e. FPE-1, -2 and -3 form a three-stage FPE. The first-stage FPE (FPE-1) can effectively filter out Mie backscattering signal, thereby suppressing its effects on wind measurement and measuring the aerosol backscatter ratio as well. The transmission spectra of the second- and third-stage FPEs (FPE-2,-3) form double edge for simultaneous wind and temperature measurements by using Rayleigh backscattering signal. The parameters of the quad FPE are optimized. The FWHM and relative peak position of FPE-1,-2,-3,-L are 0.6, 1.2, 1.2, 0.6GHz and 0, -1, 1, 0.3GHz, respectively. The performance of the proposed lidar is simulated and results show that for 0.3WSr-1m-2nm-1@355nm sky brightness, by using a 350mJ pulse energy, 50Hz repetition frequency laser and a 0.8m aperture telescope, with temporal resolution of ∼20km, ∼60km and vertical resolution of ∼10km, ∼ 20km, ∼40km, ∼60km, the measurement errors of temperature, aerosol backscattering ratio and vertical wind speed are below 5.3K, 3.0×10-3, 1.1m/s in nighttime and below 14.6K, 8.1×10-3, 2.5m/s in daytime from 0.2 to 60km altitude; the measurement error of two other orthogonal LOS wind speed with fixed zenith angle of 25.8° is below 1.3m/s in nighttime and 3.5m/s in daytime within the LOS wind speed dynamic range of ±50m/s from 0.2 to 60km altitude.

Low tropospheric wind profile from a 1.06 μm Doppler lidar

Doppler Wind Lidar Based on Fabry-Perot Etalon

Fabry-Perot interferometer based Mie Doppler lidar for low tropospheric wind observation

Low-altitude atmospheric wind measurement from the combined Mie and Rayleigh backscattering by Doppler lidar with an iodine filter

Direct Detection Doppler Wind Lidar Based on Dual FP Etalon

Mobile Rayleigh Doppler lidar for wind and temperature measurements in the stratosphere and lower mesosphere

Incoherent Doppler Lidar System Using Differential Discrimination Technique for Tropospheric Wind Measurement

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI

1.55Μm All-Fiber Coherent Doppler Lidar for Wind Measurement

High-spectral-resolution Mie Doppler lidar based on a two-stage Fabry–Perot etalon for tropospheric wind and aerosol accurate measurement

Mid-altitude wind measurements with mobile Rayleigh Doppler lidar incorporating system-level optical frequency control method

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Performance of Continuous-wave Coherent Doppler Lidar for Wind Measurement

A novel wind ladar system based on 1.55 mu m All-fiber Coherent

Data Processing and Analysis of Eight-Beam Wind Profile Coherent Wind Measurement Lidar

1.55-Μm Pulse Coherent LIDAR with 10-Km Detection Range

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Analysis of data processing method for Doppler wind lidar

All-fiber Upconversion High Spectral Resolution Wind Lidar Using a Fabry-Perot Interferometer

Low-Altitude Wind Measurement Using Incoherent Doppler Lidar by Utilizing Both Absorption Slopes of the Iodine Absorption Spectrum