Abstract:Mass spectrometry is widely used analytical technique due to its high specificity for analyte identification as well as its high sensitivity.A custom mass spectrometer instrument based on a cylindrical ion trap (CIT)was built and its working parameters were optimized.An electron ionization(EI)source was chosen for experimental simplic-ity and availability of standard EI spectral libraries.The custom designed CIT was con-sisted of a pair of endcap electrodes and a ring electrode(r0=1 0 mm,z0=8.9 7 mm).A high voltage RF signal which needed to be applied directly to the ring electrode to pro-duce appropriate quadrupole was initially created by an RF generator at low voltage.A power amplifier and a voltage amplifier circuit were used to amplify to an appropriate power level.The boundary ej ection method was used.An electron multiplier,a current amplifier and NI PCIe data acquire card made up the ion detection and data acquisition system.The EI source,CIT and electron multiplier (EM)were mounted in a rail which ensured they were aligned precisely.The software designed in LabVIEW controlled the timing of the whole system.Several MATLAB programs were written to perform post-processing operations on saved MS data files.In order to obtain the optimal working pa-rameters,different values of filament current,bias voltage of EI,background pressure, voltage on the EM detector and mass scan rate were tested in the vacuum chamber.The trends of spectral peak were obtained:1)Signal intensity increased with the heating current supplied to the EI source due to the increased electron emission at higher tem-perature;2)The bias voltage of EI affected the kinetic energy of ions.With the increas-ing of the voltage,the signal intensity increased.When the voltage increased to a cer-tain range,the intensity fluctuated.In most common EI sources,a kinetic energy of 70 V was used.So the bias voltage was set as 70 V;3)Both signal intensity and resolution increased when background pressure was increased from 1×10-4to 6×10-4Pa.When the pressure further increased,the performance decreased;4)Signal intensity was pro-portional to the voltage on the EM detector.Considering the signal intensity and the lifetime of EM,a voltage of 1.75 kV was used;5)Mass scan rate had influence on the signal intensity and resolution.When the scan rate was too fast,the various ions bunched together and increased the signal intensity but reduced the resolution.Slowing the scan rate caused the peaks to spread apart resulting in increased resolution.By using the optimized parameters,several experiments were carried out.The results showed that the mass spectrum was accurate and the resolution was about 300.The MS plat-form performed well which laid a foundation of further research.To further improve resolution,axial RF will be applied to the endcap electrode to perform resonance ej ection in the following work and based on this platform the operation method for high-pressure MS will be explored.

Optimization of Multi-Reflection Time-of-flight Mass Analyzer Operating in In-Trap-lift Mode

A Multi-Reflection Time-of-Flight Analyzer with a Long Focus Lens

A Perspective of Multi‐Reflecting TOF MS

Accurately accounting for effects on times-of-flight caused by finite field-transition times during the ejection of ions from a storage trap: A study for TOF and MRTOF mass spectrometry

A novel time-of-flight mass spectrometer using radial extraction from a linear quadrupole trap for atomic, molecular, and chemical physics

Improved Miniaturized Linear Ion Trap Mass Spectrometer Using Lithographically Patterned Plates and Tapered Ejection Slit

High efficiency tandem mass spectrometry analysis using dual linear ion traps.

A Strategy for Simultaneously Improving Resolution and Sensitivity of Hybrid Quadrupole Ion Trap/Time-of-Flight Mass Spectrometry Using Square Waveform Phase Modulation

Development of a Low Power Miniature Linear Ion Trap Mass Spectrometer with Extended Mass Range

Stimulated Motion Suppression (STMS): a New Approach to Break the Resolution Barrier for Ion Trap Mass Spectrometry.

A Stop-Timing Microchannel Plate Detector For Multi-Reflection Time-Of-Flight Mass Analyzer

Tandem-in-time Mass Spectrometry Analysis Facilitated by Real-Time Pressure Adjustments

A compact ion source combining electron-impact and thermal ionization for multiple-reflection time-of-flight mass spectrometry

Computer Simulations of a New Toroidal-Cylindrical Ion Trap Mass Analyzer

Status of Lanzhou Penning Trap for Accurate Mass Measurements

Novel Control Modes to Improve the Performance of Rectilinear Ion Trap Mass Spectrometer with Dual Pressure Chambers

Research on Key Techniques of Cylindrical Ion Trap Mass Spectrometer and Parameters Optimization

Design of A Photoelectron/Ion Imaging Spectrometer with High Temporal Resolution

Analytical Performance of a Microsecond-pulse Glow Discharge Time of Flight Mass Spectrometer.

A small high-irradiance laser ionization time-of-flight mass spectrometer.

Optimization of Performance of Toroidal Ion Trap with Trianglar Electrode by Theoretical Simulation