Abstract:The valence states of copper-based catalyst are still controversial for whether Cu+ exists or even dominates the corresponding catalysis performance, especially for the catalyst prepared by unconventional method. For example, Cu/SiO2 catalyst prepared by deposition-precipitation exhibits different ratio of Cu-0 and Cu+ in the literatures. Zinc-doping Cu/SiO2 catalyst is primarily chosen for carbonyl hydrogenation. Additionally, the copper, catalysts employed in the industrial reactor require a doping of zinc for catalyst stability and relatively low temperature reduction, which makes they valence states of copper catalyst under working conditions even more complicated. In this paper, copper phyllosilicate, 15 w1% Cu-5.0 wt% Zn/SiO2, was prepared by ammonia evaporation method with the following procedures: (1) complexation of Cu/Zn to silicasol by mixing of an amount of copper ammonia solution (0.5 mol/L) and zinc ammonia solution (0.5 mol/L) with silicasol (5%, SiO2) for 5 h at room temperature, and then decomposition of metal ammonia under 95 degrees C; (2) dried, crushed and calcined at 450 degrees C for 4 h. The Cu/SiO2 catalyst precursor without the addition of zinc was prepared with the same procedures as Cu-Zn catalyst precursor. The valence states of copper catalyst of Cu-Zn/SiO2 and Cu/SiO2 catalyst during hydrogen reduction in the temperature range of 20 degrees C to 350 degrees C has been studied by in situ X-ray absorption spectroscopy characterization under the atmosphere of 10% H-2 in He, 50 mL/min. Valence state composition was analyzed by using Linear Combination Fitting (LCF) method based on X-ray Absorption Near Edge Spectroscopy (XANES) spectra, which indicated: (1) the reduction degree of Cu2+ to Cu-0 is increased with the addition of zinc; (2) Cu+ occurred and mainly existed at low reduction temperature (<250 degrees C) with a low concentration, but it diminished completely at high reduction temperature; (3) Cu-0 could be the active center for hydrogenation of methyl acetate to ethanol.

Quantitative Control and Identification of Copper Species in Cu–SAPO-34: a Combined UV–vis Spectroscopic and H 2 -TPR Analysis

Quantitative control and identification of copper species in Cu–SAPO-34: a combined UV–vis spectroscopic and H2-TPR analysis

New Insight into Cu/SAPO-34 Preparation Procedure: Impact of NH4-SAPO-34 on the Structure and Cu Distribution in Cu-SAPO-34 NH3-SCR Catalysts

Improvement of Low-Temperature Hydrothermal Stability of Cu/Sapo-34 Catalysts by Cu2+ Species

Nature Identification of Cu Active Sites in Sulfur-Fouled Cu/SAPO-34 Regeneration

Evolution of Copper Species on Cu/SAPO-34 SCR Catalysts Upon Hydrothermal Aging

The enhanced catalytic activity of Cu/SAPO-34 by ion exchange method for selective catalytic reduction of nitric oxide

Migration, Reactivity, and Sulfur Tolerance of Copper Species in SAPO-34 Zeolite Toward NOx Reduction with Ammonia

A reconstruction strategy for the synthesis of Cu-SAPO-34 with excellent NH3-SCR catalytic performance and hydrothermal stability

Effect of Cu loading on the performance and kinetics of Cu/SAPO-34 catalysts for selective catalytic reduction with NH3

The Migration of Cu Species over Cu–SAPO-34 and Its Effect on NH3 Oxidation at High Temperature

Migration of Cu Species in Cu/SAPO-34 During Hydrothermal Aging

Location and Nature of Cu Species in Cu/SAPO-34 for Selective Catalytic Reduction of NO with NH3

Quasi-operando Quantification of Cu(ii) Ions in Cu-SSZ-13 Catalyst by an NH3 Temperature-Programmed Reduction Method

In Situ X-ray Absorption Spectroscopy Characterization of Copper Valence State in Cu-Zn/SiO2 Catalyst

The Influence of Crystallite Size on the Structural Stability of Cu/SAPO-34 Catalysts

A controllable zeolite framework stability of Cu/SAPO-34 via adjusting the copper coordination environment for NH 3 -SCR under hydrothermal condition

Investigation on Removal of NO and Hg-0 with Different Cu Species in Cu-SAPO-34 Zeolites

The Role of Pore Diffusion in Determining Nh3 Scr Active Sites over Cu/Sapo-34 Catalysts

Quantitative Cu Counting Methodologies for Cu/SSZ-13 Selective Catalytic Reduction Catalysts by Electron Paramagnetic Resonance Spectroscopy

Quasi- operando quantification of Cu( ii ) ions in Cu-SSZ-13 catalyst by an NH 3 temperature-programmed reduction method