Simultaneously Measurements of the PVT and Thermal – Pressure Coefficient of Benzene in the Critical and Supercritical Regions
Nikolai G. Polikhronidi,Rabiyat G. Batyrova,Jiangtao Wu,Ilmutdin M. Abdulagatov
DOI: https://doi.org/10.1016/j.molliq.2019.111381
IF: 6
2019-01-01
Journal of Molecular Liquids
Abstract:The values of pressure (P), the temperature derivative, gamma(v) = (partial derivative P/partial derivative T)(v), and the density (rho) of benzene have been simultaneously measured in the near- and supercritical regions using high-temperature and high-pressure piezo-calorimeter. Measurements were made along 10 liquid and vapor isochores between (265.5 and 653.9) kg.m(-3) and at temperatures from (346.03 to 615.92) K and at pressures up to 9.171 MPa. For each isochore most measurements were made in the immediate vicinity of the liquid-gas phase transition temperature (single- and two-phase regions) where the break of the P-T isochores and the jumps of the thermal-pressure coefficient gamma(v) are observing. Temperatures and pressures (T-s, P-s) at the liquid-gas phase transition curve for each constant density (isochore, rho) and the critical parameters (T-C,P-C,rho(C)) for benzene were measured using the isochoric P - T break point and thermal -pressure coefficient jump techniques. The expanded uncertainty of the pressure (P), density (rho), and thermal -pressure coefficient (gamma(v)) measurements at the 95% confidence level with a coverage factor of k = 2 is estimated to be, 0.16%, 0.05% and (0.12 to 1.5) % (depending on temperature and pressure), respectively. The measured pressures (PVT) and thermal -pressure coefficients (gamma vVT) have been used to calculate of the internal pressure (or energy-volume coefficient) as (partial derivative U/partial derivative V)(T) = T(partial derivative P/partial derivative T)(v) -P. We have also measured the temperature derivatives of the internal energy (partial derivative U/partial derivative V)(v) = C-v (isochoric heat capacity) using the same piezocalorimetric cell. The effect of pressure and temperature on the internal pressure was studied. isochoric P-T curve break point and isochoric thermal-pressure coefficient jump techniques were used to accurately determine of the phase transition and critical points parameters. The measured values of the thermal-pressure coefficient were interpreted in term of scaling theory of critical phenomena. The measured values of pressure (P), temperature derivative, (partial derivative P/partial derivative T)(v), temperature and density at the saturation curve together with our previous isochoric heat capacity measurements were used to calculate other thermodynamic properties of benzene at saturation curve. (C) 2019 Elsevier B.V. All rights reserved.