Abstract:The values of pressure (P), the temperature derivative, gamma(v) = (partial derivative P/partial derivative T)(v), and the density (rho) of benzene have been simultaneously measured in the near- and supercritical regions using high-temperature and high-pressure piezo-calorimeter. Measurements were made along 10 liquid and vapor isochores between (265.5 and 653.9) kg.m(-3) and at temperatures from (346.03 to 615.92) K and at pressures up to 9.171 MPa. For each isochore most measurements were made in the immediate vicinity of the liquid-gas phase transition temperature (single- and two-phase regions) where the break of the P-T isochores and the jumps of the thermal-pressure coefficient gamma(v) are observing. Temperatures and pressures (T-s, P-s) at the liquid-gas phase transition curve for each constant density (isochore, rho) and the critical parameters (T-C,P-C,rho(C)) for benzene were measured using the isochoric P - T break point and thermal -pressure coefficient jump techniques. The expanded uncertainty of the pressure (P), density (rho), and thermal -pressure coefficient (gamma(v)) measurements at the 95% confidence level with a coverage factor of k = 2 is estimated to be, 0.16%, 0.05% and (0.12 to 1.5) % (depending on temperature and pressure), respectively. The measured pressures (PVT) and thermal -pressure coefficients (gamma vVT) have been used to calculate of the internal pressure (or energy-volume coefficient) as (partial derivative U/partial derivative V)(T) = T(partial derivative P/partial derivative T)(v) -P. We have also measured the temperature derivatives of the internal energy (partial derivative U/partial derivative V)(v) = C-v (isochoric heat capacity) using the same piezocalorimetric cell. The effect of pressure and temperature on the internal pressure was studied. isochoric P-T curve break point and isochoric thermal-pressure coefficient jump techniques were used to accurately determine of the phase transition and critical points parameters. The measured values of the thermal-pressure coefficient were interpreted in term of scaling theory of critical phenomena. The measured values of pressure (P), temperature derivative, (partial derivative P/partial derivative T)(v), temperature and density at the saturation curve together with our previous isochoric heat capacity measurements were used to calculate other thermodynamic properties of benzene at saturation curve. (C) 2019 Elsevier B.V. All rights reserved.

Isobaric Heat Capacity Measurements for 1,3-Diethylbenzene from 303 K to 489 K and Pressure Up to 12 MPa

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Heat Capacity of Isobutane in Liquid Phase at Temperatures from 303 K to 413 K and Pressures Up to 12 MPa

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Measurements of Isobaric Heat Capacity of R143a and R227ea at Liquid Phase by Quasi-Steady Scanning

Experimental Study of Pvtx Properties in the Gas Phase for Binary Mixtures of Dme and Hfc-134a

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Isobaric Heat Capacity Measurements for R1234yf from 303 to 373 K and Pressures Up to 12 Mpa

Isobaric Heat Capacities of R245fa and R236fa in Liquid Phase at Temperatures from (315 to 365) K and Pressures Up to 5.5 MPa

Thermal conductivity of liquid diethyl ether, diisopropyl ether, and di-n-butyl ether from (233 to 373) K at pressures up to 30 MPa

Measurements of density and heat capacity for binary mixtures { x benzonitrile + (1-x) (octane or nonane)}

Measurements of Density and Heat Capacity for Binary Mixtures {x Benzonitrile + (1 −x) (octane or Nonane)}

Experimental-Determination of the Isobaric Specific-Heat Capacities of Multicomponent Vapors Up to Temperatures of 600-K

Densities, Isobaric Thermal Expansion Coefficients and Isothermal Compressibilities of Linear Alkylbenzene

Simultaneously Measurements of the PVT and Thermal – Pressure Coefficient of Benzene in the Critical and Supercritical Regions

Measurement of the Thermal Conductivities of Toluene, Cyclohexane, and Diethyl Ether at Pressures up to 15.1 MPa and Their Binary Mixtures at Pressures 0.1 and 10.1 MPa from 291 to 351 K

Thermal Diffusivity and Specific Heat Capacity of Linear Alkylbenzene

Isobaric Molar Heat Capacity of Ethyl Octanoate and Ethyl Decanoate at Pressures Up to 24 MPa

Thermal Conductivity of Liquid 1, 2-Dimethoxyethane from 243K to 353K at Pressures up to 30MPa