Abstract:<p>With the rapid development of manufacturing technology in the fields such as aerospace, aviation, national defense, and automobiles, the demands for lightweight, toughening, and forming accuracy of products have increased. As one of the main defects in the plastic forming of thin-walled components, wrinkling failure has always been a key element in forming control. The sheet metal is restrained by the mold in actual forming process and the wrinkling is significantly affected by the boundary conditions. To study the effect of the mold constraints on the wrinkling failure in the actual forming process, a stretching wrinkling test of wedge plate with the boundary constraint conditions of mold was designed. By establishing the simulation model for wrinkling failure of sheet forming under mold constraints and its wrinkling limit diagram (WLD), the accurate prediction of sheet metal wrinkling failure form and the critical state in actual forming was realized. At the beginning of the research, the wedge plate tensile test was implemented for using as verification for simulation results, then the wrinkle simulation model of Buckle-Dynamic with the instability mode as the initial defect was established. By combining with the non-contact full-field strain measurement system DIC to obtain the strain data of the specimens in the test process, the accuracy of the simulation model was verified. On this basis, the critical wrinkling limit diagram (WLD) was established for the wrinkle partition on the wedge specimen, and the influence of stress state, stress loading path, principal compressive stress increment, principal stress ratio factors on the distribution and propagation direction of wrinkles, as well as the morphology and characteristics of WLD are discussed. The research content of this study is of guiding significance for the prediction of the actual wrinkling failure of sheet and shell forming.</p>

Theoretical Prediction of Sheet Metal Wrinkling Based on the Potential Function Analysis

Theoretical Prediction of Flange Wrinkling in the First-Pass Conventional Spinning of Dual-Metal Sheets

Plastic wrinkling prediction in thin-walled part forming process: A review

Predicting the wrinkling in AA5052 seamless tubes manufactured by free bending forming technology

Formability limits by wrinkling in sheet metal forming

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

An analytical model for designing defect-free sheet metal profiles with height-variable cross sections manufactured by Flexible Roller Beading

Study on the mechanism of wrinkle flattening under internal pressure and the critical condition of dead wrinkle

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Fracture prediction for metal sheet deformation under different stress states with uncoupled ductile fracture criteria

Prediction of wrinkle patterns in tensioned thin-film structures containing rigid elements

A Mesoscopic Analytical Model to Predict the Onset of Wrinkling in Plain Woven Preforms under Bias Extension Shear Deformation

An improved Marciniak-Kuczynski approach for predicting sheet metal formability

Effects of anisotropic yield criteria on the prediction of wrinkle during the deep-drawing forming of aluminum alloy sheet

Study on the wrinkling behavior of perforated metallic plates using uniaxial tensile tests

Efficient approach to plastic wrinkling prediction for multi-intersecting stiffened panels in spherical die forming

A separation-of-variable method for the wrinkling problems of orthotropic rectangular stretched sheets

A Hierarchical Prediction Method Based on Hybrid-Kernel GWO-SVM for Metal Tube Bending Wrinkling Detection

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

A Novel Method for Friction Coefficient Calculation in Metal Sheet Forming of Axis-Symmetric Deep Drawing Parts

Prediction of Wrinkling of a Beverage Can Subjected to the Redrawing Process by J2 Deformation Theory