Tetrabasic Lead Sulphate Micro-Rods As Positive Active Material for Lead Acid Battery

Zhenzhen Fan,Beibei Ma,Wei Liu,Fajun Li,Yanqing Zhou,Jian Tai,Xiaoyuan Zhao,Lixu Lei

DOI: https://doi.org/10.20964/2018.06.79

IF: 1.541

2018-01-01

International Journal of Electrochemical Science

Abstract:It is well known that positive electrodes with high content of tetrabasic lead sulphate (4PbO center dot PbSO4, short as 4BS) can improve the cycle performance of lead acid batteries (LABs). To achieve this, the positive plates are usually fabricated with addition of 4BS micro-crystals and long-time curing at high temperature, which is very costly. Herein, we report a fast and feasible route to produce 4BS, which are micro-rods of about 10 mu m in length and 1 mu m in diameter. In this article, we show a comparison of the electrochemical performances of the original as-prepared 4BS and pulverised 4BS crystals (dimensions of 0.5 to 2 mu m) in positive electrodes. The original 4BS shows much better performances than the pulverised. The original discharges a capacity of more than 100 mAh g(-1) even after 1000 cycles of 100% DOD (depth of discharge) at 100 mA g(-1) in a flooded cell. Moreover, addition of 10% Pb3O4, 0.5% Sb2O3 and 0.5% SnSO4 to the original 4BS increases the discharge capacity to 121.0 mAh g(-1). Therefore, we conclude that 4BS micro-rods can be directly used as the positive active material, which simplifies and unifies the production of LABs.