Abstract:For lead recovery from spent LABs paste, chemical reagents consumption, lead yield, and environmental risk are crucial factors for the low‐cost sustainable development of recycled lead enterprises. Herein, a closed‐loop lead recovery strategy is demonstrated through Na2MoO4 consumption–regeneration–reuse. Noteworthily, 99.83 wt% of Na2MoO4 is reused and 95.27 wt% of Pb is recycled without generating wastewater and slags. Recycling of spent lead‐acid batteries (LABs) is extremely urgent in view of environmental protection and resources reuse. The current challenge is to reduce high consumption of chemical reagents. Herein, a closed‐loop spent LABs paste (SLBP) recovery strategy is demonstrated through Na2MoO4 consumption‐regeneration‐reuse. Experimental and DFT calculations verify that MoO42− competes Pb/Ca ions and weakens the metal‐oxygen bond of PbSO4/CaSO4.2H2O in SLBP, facilitating PbMoO4/CaMoO4 formation and 99.13 wt% of SO42− elimination. Pb of 99.97 wt% is obtained as zero‐carbon precursors (PbO2 and PbMoO4) by green leaching coupled with re‐crystallization. The regeneration of Na2MoO4 is realized at 600 °C using LABs polypropylene shells and NaOH as reagents. Compared with the traditional smelting technologies, the temperature is reduced from >1000 to 600 °C. The extraction of Na2MoO4 require only water, and satisfactory re‐used desulfurization efficiency (98.67 wt%) is achieved. For the residual Na2MoO4 after first SLBP desulfurization, the desulfurization efficiency remains above 97.36 wt% after adding fresh reagents for two running cycles. The new principle enables the reuse of 99.83 wt% of Na2MoO4 and the recycling of 95.27 wt% of Pb without generating wastewater and slags. The techno‐economic analysis indicates this strategy is efficient, economical, and environmentally‐friendly.

Improving the performance of recovered lead oxide powder from waste lead paste as active material for lead‐acid battery

Using silkworm excrement and spent lead paste to prepare additives for improving the cycle life of lead-acid batteries

Preparation of lead sulfide‐lead carbon black composites by microwave method to improve the electrical properties from recycled lead powder

An innovative synergistic recycling route of spent lead paste and lead grid based on sodium nitrate reuse

Directly Recovering Lead and Recycling Electrolyte via Electrolyzing Desulfurized Lead Paste with PVDF as Binder

In-situ carbon encapsulated Pb/PbO nanoparticles derived from spent lead paste for lead-carbon battery

Quasi-solid synthesis of nano-Pb/C composites for enhanced performance of lead-acid battery

An Acid-Pasting Strategy Towards PTCDA Based High Performance Lithium/sodium Ion Battery Cathodes

From Lead Paste to High-Value Nanolead Sulfide Products: A New Application of Mechanochemistry in the Recycling of Spent Lead–Acid Batteries

Efficient Desulfurizer Recycling during Spent Lead–Acid Batteries Paste Disposal by Zero‐Carbon Precursor Hypothermic Smelting

Rapid recovery of high pure PbO from spent lead acid battery without desulfation and chemicals consumption method

Analysis of a more sustainable method for recycling waste lead batteries: Surface renewal promotes desulfurization agent regeneration

A Layered-Carbon/pbso4 Composite As a New Additive for Negative Active Material of Lead-Acid Batteries

An environment-friendly strategy for recovery of α-PbO from spent lead paste: Based on the thermochemical reduction of PbO 2 with ammonium sulfate

Efficient Desulfurizer Recycling during Spent Lead-Acid Batteries Paste Disposal by Zero-Carbon Precursor Hypothermic Smelting

Preparation of High Purity Lead Oxide from Spent Lead Acid Batteries via Desulfurization and Recrystallization in Sodium Hydroxide

Chemical-Free Method for Recovery of Lead from Spent Lead Paste by Reductive Sulfation Technique from By-product Utilization

Reconstruction of Lead Acid Battery Negative Electrodes after Hard Sulfation Using Controlled Chelation Chemistry

Recycling of mixed lithium-ion battery cathode materials with spent lead-acid battery electrolyte with the assistance of thermodynamic simulations

An Innovative Process for the Direct Recovery of Lead from Waste Lead Paste

Investigation of discharged positive material used as negative additive for lead-acid battery