Abstract:The coherent passive optical network (PON) is a cost-effective point-to-multipoint solution to accommodate the ever-increasing traffic demands in the future optical access network. Recently, time and frequency division multiplexing (TFDM) coherent PON have attracted increasing interest, due to its advantages of providing low latency access and flexible bandwidth allocation. One critical challenge for TFDM-PON system is the upstream burst-mode digital signal processing (DSP). DSP should converge fast in the specific time slot to ensure low latency for subcarrier allocation. The conventional subcarrier recognition and demultiplexing are realized in the frequency domain. The process of time-frequency conversion introduces extra computational complexity if the burst-mode DSP use time-domain algorithms. In this paper, we propose and experimentally demonstrate a data-aided DSP scheme for burst-mode detection in coherent TFDM-PON. Subcarrier demultiplexing is implemented in the time domain by using coarse and fine filtering. Coarse and fine filtering are achieved by convolving the signal with finite impulse response (FIR) pulse-shaping filters. Least square (LS) algorithm is used for channel estimation achieving fast convergence. With a 79.36-ns training sequence, -37.5-dBm and -29-dBm sensitivities are achieved for QPSK and 16QAM signal-based 200G TFDM-PON with four subcarriers after 20-km fiber transmission.

Real-Time FPGA Demonstration of PAM-4 Burst-Mode All-Digital Clock and Data Recovery for Single Wavelength 50G PON Application

FPGA-Based Demonstration of WDM-PAM4-PON System with Low-Complexity CMA

FPGA-based 4 × 29.4912 Gbit/s PS-PAM4 signal transmission with a low-complexity probabilistic shaping scheme.

8 × 10 Gb/s Downstream PAM-4 Transmission for Cost-Effective Coherent WDM-PON Application

A Novel 10 Gb/S Tdm-Pon Using Embedded Clocks in Centralized Optical Signals and Conventional Cw Receivers for Instantaneous Burst-Mode Data and Clock Recovery

Burst-mode Signal Reception for 200G Coherent Time and Frequency Division Multiplexing Passive Optical Network

64-Gb/s/a Downstream Transmission for PAM-4 TDM-PON with Centralized DSP and 10G Low-Complexity Receiver in C-Band

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

8×250 Gbit/s PAM4 Transmission over 1 Km Single Mode Fiber with an All-Silicon LAN WDM Transmitter.

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

FPGA Implementation for 44.2368-Gbit/s PAM8 Signal Transmission with Pruned Pre-Equalization.

Symmetrical 50-Gb/s/λ PAM-4 TDM-PON at O-Band Supporting 26 Db+ Loss Budget Using Low-Bandwidth Optics and Semiconductor Optical Amplifier.

Single-Wavelength 100-Gb/s PAM-4 TDM-PON Achieving over 32-Db Power Budget Using Simplified and Phase Insensitive Coherent Detection.

A 25gb/s 185mw PAM-4 Receiver with 4-Tap Adaptive DFE and Sampling Clock Optimization in 55nm CMOS

Dual-wavelength clock recovery with simultaneous fourfold demultiplexing using an optoelectronic oscillator

A 56Gb/s De-serializer with PAM-4 CDR for Chiplet Optical-I/O

40Gbits/s All-Optical Clock Recovery for Degraded Signals Using an Amplified Feedback Laser

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

Optoelectrical Clock Recovery with Dispersion Monitoring for High Speed Transmission

A 32-Gb/s 0.46-pJ/bit PAM4 CDR Using a Quarter-Rate Linear Phase Detector and a Self-Biased PLL-Based Multiphase Clock Generator

A 60-Gb/s 1.2-pJ/bit 1/4-Rate PAM-4 Receiver With a Jitter Compensation CDR