Abstract:Overloaded truck and earthquake have become two main factors responsible for bridge damage, consequently the combination of heavy truck and seismic loads as a typical occurrence of extreme events is likely to lead to bridge collapse or destructive damage, in which the crucial issues of coupling load model, dynamic equations and bridge responses have not been adequately addressed. In this study, a simplified vehicle-bridge model consisting of many containers is established to simulate vehicle passage, and the dynamic equations are derived for a 5-axle truck on a simply supported beam as an illustration. Then, five ground motions selected from PEER with appropriate peak ground accelerations and durations and the three truck models specified in American Association of State Highway and Transportation Officials, Caltrans and Chinese codes are applied on the finite element model of a typical reinforced concrete continuous girder bridge, in which, vehicle speed, number of trucks, ground motion and vehicle type are assumed to be random variables and their influences on dynamic responses of the bridge are analyzed. The results show seismic load is the governing factor in dynamic responses but truck load may change displacement shapes; in addition, dynamic responses present a high sensitivity with the number of trucks (set as truck platoon) and gross vehicle weight but rare with vehicle speed. Specifically, the presence of a few trucks could serve as energy dissipation facilities for the bridge under seismic motions but may amplify the response when more trucks involved; some combinations of truck platoon with seismic excitation produce very large displacements and even cracks on the bridge, therefore, such an extreme event requires higher robustness in bridge design to make it be sustainable and serviceability after earthquakes.

Response Spectrum-Based Method for Calculating the Reaction Force of Piers Subjected to Truck Collisions

Reduced Models for Simulating Collisions Between Trucks and Bridge Piers

General Reduced Vehicle Model for Simulating Truck-Bridge Pier Collisions

Site-Specific Fatigue Load Spectrum for Urban Bridges

Test and Numerical Simulation of Truck Collision with Anti-Ram Bollards

Impact Tests of Model RC Columns by an Equivalent Truck Frame

Impact Response Spectrum for Vessel-Bridge Collision Design

Analysis of Response Spectrum for Random Pedestrian Loads

Finite-element and simplified models for collision simulation between overheight trucks and bridge superstructures

RMS Acceleration Response Spectrum Method for Single-Span Footbridges under Pedestrian Load

Development and Assessment of Efficient Models for Barge Impact Processes Based on Nonlinear Dynamic Finite Element Analyses

General contact response of single-axle two-mass test vehicles for scanning bridge frequencies considering suspension effect

A vehicle-bridge interaction model considering contact patch size and vehicle self-generated excitation – A theoretical study

Dynamic Response and Impact Force Calculation of PC Box Girder Bridge Subjected to Over-Height Vehicle Collision

Impact analysis of I-Lam sandwich system for over-height collision protection of highway bridges

Performance assessment of steel parking structure columns subjected to frontal collision based on reduced vehicular models

Dynamic response performance of bridge piers under non-bottom vehicle collision

Simplified Model and Design Equations for the Collision between Over-high Truck and Bridge Superstructures

Response and Shear Mechanism of RC Bridge Piers Confined with CFRP Grid-Reinforced ECC Subjected to Truck Collision

Dynamic Responses of RC Girder Bridge under Heavy Truck and Seismic Loads Combined

Identification of a bridge's structural damage and vehicular parameters based on dynamic response sensitivity analysis