Abstract:In helically coiled tubes, the geometry-induced centrifugal force exerts upon the fluid to make the dry out phenomenon complicated. Hence, it is essential to understand the dryout mechanism and develop a model to accurately predict the dryout quality and dryout pattern in helically coiled tubes that can cover a wide range of parameters. In this paper, 17 helically coiled tubes with different coil diameters (160-1350 mm), inner diameters (9-14 mm) and inclined angles (2.5 similar to 10 degrees) are used to conduct the experimental study of the dryout characteristic under different conditions, including pressure between 2 and 7 MPa, mass flow rate between 100 and 10 0 0 kg/(m(2)center dot s), heat flux between 50 and 700 kW/m(2). Three types of dryout patterns in helically coiled tubes were observed by analyzing the circumferential distribution of the wall temperature, including the gravity-dominated pattern, the secondary-flow-dominated pattern and the centrifugal-force-dominated pattern. Then the effects of the operational and geometric parameters of helically coiled tubes on the dryout characteristic have been studied, such as system pressure, mass flow rate, heat flux, tube diameter and coil diameter. Finally, a "dryout map" was developed based on the experimental data (297 data points), and an analytical model of dryout quality was proposed in terms of dimensionless groups for each zone. The correlations were verified by comparing with the experimental results in the open literature. The proposed correlations in this paper can give a better prediction for different experimental results. (c) 2021 Elsevier Ltd. All rights reserved.

Hydrodynamics of Continuous Spiral Dryer with Rotatory Conical Sleeves: Experiments Versus CFD Simulations

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Laminar mixed convection heat transfer of SiC-EG nanofluids in a triangular enclosure with a rotating inner cylinder: simulations based on the measured thermal conductivity and viscosity

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Film Formation in a Horizontal Twin-Shaft Rotating Disk Reactor for Polymer Devolatilization

Multi-phase Flow and Drying Characteristics in a Semi-Circular Impinging Stream Dryer

CFD-DEM simulation of cyclone self-rotation drying: Particle high-speed self-rotation and heat transfer

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

Numerical Investigation of the Effect of Surface Wettability and Rotation on Condensation Heat Transfer in a Sludge Dryer Vertical Paddle

Numerical Simulation and Analysis of Effect of Injection Volume on Biomass Particle Cyclone Venturi Dryer

CFD Simulation of the Hydrodynamic Behavior in an Internally Circulating Fluidized Bed Reactor for Producing Polysilicon Granules

Super-quadric CFD-DEM modelling of chip-like particle-liquid flow in a rotary drum

CFD-DEM Study of heat and mass transfer of ellipsoidal particles in fluidized bed dryers

CFD-DEM investigation of the gas-solid flow characteristics in a fluidized bed dryer

Dem Simulation of Wet Granular-Fluid Flows in Spouted Beds: Numerical Studies and Experimental Verifications

Hydrodynamic Investigation of Ultraclean Wafer Drying Combining Marangoni Effect and Centrifugal Force

Comparison of computational fluid dynamics–discrete element method and discrete element method simulations for a screw conveyor

Study of the performance and flow field of a new spiral-roof cyclone separator

Diabatic visualization study of R245fa two phase flow pattern characteristics in horizontal smooth and microfin tube

Development of an analytical model for the dryout characteristic in helically coiled tubes

Flow and Heat Transfer Characteristics of Materials in the Flighted Rotary Dryer