Abstract:Conventional flighted rotary drums usually have flights parallel to the rotating axis, which cannot facilitate the axial motion of the materials in the drum. Here, a new type of horizontal rotary drum with inclined flights and beads was designed. Inclined flights are used to facilitate the axial movement of beads and material, while beads are used as fillers to increase the gas-liquid contact area and to crush the solid materials. We simulated the drum and studied the axial motion of fillers using the discrete element method (DEM). To improve the mass and heat transfer performance, we optimized the distribution of beads in the active phase. The effects of the rotational speed, joint angle, and inlet flow rate in the drum were investigated systematically. The individual effects were evaluated in terms of the mass of particles in the active phase (MAP) and passive phase (MPP), the percentage of the active phase occupied by the particles (OAR), and the axial speed (AS). The response surface methodology (RSM) was used to investigate the significant effects of the interaction between the parameters. The maximum MAP value can be obtained by the following parameters: a rotational speed of 37 rpm, joint angle of 139°, and inlet flow rate of 7.83 kg/s. The interaction between rotational speed and inlet flow rate is the most significant for MAP. The joint angle and inlet flow rate have a significant interactive effect on AS. Besides, the rotational speed, joint angle and inlet flow rate show an interactive effect on OAR and AS. Based on the optimization results, the effect of the inclined angle on the axial motion of beads was also evaluated. The axial motion of the beads occurs mainly in the active phase. Compared to the drum without inclined flights, the drum with inclined flights has an enhanced axial speed increased by 26%. This study will be helpful for the design and optimization of drums with inclined flights.

Super-quadric CFD-DEM modelling of chip-like particle-liquid flow in a rotary drum

Multi-level Coarse-Grained Discrete Element Method Modeling of Cylinder Particle Flow in a Rotating Drum

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Simulation of Biomass Pyrolysis in a Rotary Drum by Coupling CFD-DEM with a One-Dimensional Thermally Thick Model

Numerical investigation of the particle flow behaviors in a fluidized-bed drum by CFD-DEM

Modelling of the Flow of Ellipsoidal Particles in a Horizontal Rotating Drum Based on DEM Simulation

Investigating the Flow of Rod-Like Particles in a Horizontal Rotating Drum Using DEM Simulation

Three-dimensional axial dispersion dynamics of granular flow in the rolling-regime rotating drum

An Experimentally Validated Coarse-Grain DEM Study of Monodisperse Granular Mixing

CFD-DEM Modeling of Rod-Like Particles in a Fluidized Bed with Complex Geometry

Numerical and Experimental Study of Radial Segregation of Bi-Disperse Particles in a Quasi-Two-dimensional Horizontal Rotating Drum

DEM investigation of the axial dispersion behavior of a binary mixture in the rotating drum

Granular surface flow in a two-dimensional rotating drum: Particle dynamics simulation

Multi-level coarse-grained DEM modelling of cylinder particle flow in a rotating drum

DEM simulation and analysis of particle mixing and heat conduction in a rotating drum

DEM Simulation of a Rotary Drum with Inclined Flights Using the Response Surface Methodology

2D DEM Simulation of Particle Mixing in Rotating Drum: A Parametric Study

Numerical Simulation of Different Flow Regimes in a Horizontal Rotating Ellipsoidal Drum

Three-dimensional DEM Simulation of Polydisperse Particle Flow in Rolling Mode Rotating Drum

Qualitative and quantitative analyses of particulate flows in rotating drums using a DEM-based approach

CFD-DEM Simulation of Fluidized Bed with an Immersed Tube Using a Coarse-Grain Model