Abstract:Abstract The running-in of cylinder liner-piston rings (CLPRs) is the most important process that must be performed before a marine diesel engine can be operated. The quality of running-in directly affects the reliability of a CLPR. The surface texture of a CLPR has been proven to significantly affect its lubrication performance. In this study, the tribological behavior of a CLPR during running-in is investigated. Three types of surface textures are generated on the CLPR via laser processing: dimple texture on piston rings, groove texture on cylinder liners, and co-texture on both sides. Subsequently, a series of tests are performed on a slice tester. A load of 300 N (1.64 MPa) is applied, and two speeds (50 and 100 rpm) are adopted. The CLPR running-in quality is characterized based on three parameters, i.e., the friction coefficient, contact resistance, and wear topography. Experimental results show that, compared with a non-textured surface, the three types of surface textures mentioned above improved the friction performance during running-in. The lubricant supply capacity of the dimple texture on the piston ring, as a mobile oil reservoir, is stronger than that of the groove texture on the cylinder liner serving as a static oil reservoir. By contrast, the wear resistance of the dimple texture, as a movable debris trap on the piston ring, is weaker than that of the groove texture on the cylinder liner, which serves as a static debris trap. It is demonstrated that the co-texture combines the advantages of dimples and groove textures. Compared with non-textured surfaces, the friction coefficient decreased the most at 100 rpm (44.5%), and the contact resistance improved the most at 50 rpm (352.9%). The coupling effect provides the surface with improved running-in quality by optimizing the tribological performance, particularly at the dead center. This study provides guidance for the tribological design and manufacturing of CLPR in marine diesel engines.

Study on the Frictional Performance of Slide and Plateau Honed Cylinder Liners During Running-in

Mutual influence of plateau roughness and groove texture of honed surface on frictional performance of piston ring–liner system

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Tribological behavior of co-textured cylinder liner-piston ring during running-in

Reciprocating sliding friction behavior and wear state transition mechanism of cylinder liner and piston ring

Tribological Design of the Running-in Process

The influence of piston ring geometry and topography on friction

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Sliding Behaviour of Friction Material Against Cermet Coatings: Pin-on-Disc Study of the Running-in Stage

Coupled evolution process of lubrication and wear in piston-liner interface of high-pressure common rail pumps

Effects of Liner Surface Textures on the Tribological Performance of Different Production Piston Rings

Investigation On The Performance Of Compression Ring-Cylinder Liner System Under Starved Lubrication

Simplified Wear Model for Power Cylinder under Engine Operating Conditions

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly

Simulation and experimental investigation on low wear rate surface contour of piston/cylinder pair in an axial piston pump

Effects of the Piston Skirt's Surface Structure on Coating Quality and Friction Functions

Wear model based on real-time surface roughness and its effect on lubrication regimes

On Lubrication States after a Running-In Process in Aqueous Lubrication.

Influence of Different Surface Texture Parameters on the Contact Performance of Piston Ring-Sleeve Friction Pair of Hydraulic Cylinders

A new efficient flow continuity lubrication model for the cylinder liner‐piston ring based on the locally oriented roughness

Effects of different surface textures on tribological performances of the cylinder liner-piston ring: An experimental study