Progress of Gas-solid Interaction Behavior and Spray System of High Velocity Low Temperature Spray
Shiyue Ma,Meijun Liu,Guanjun Yang,Changjiu Li
DOI: https://doi.org/10.11933/j.issn.1007-9289.20230327002
2024-01-01
China surface engineering
Abstract:High-velocity low-temperature spray is a spray method that utilizes a solid-phase powder or a low-temperature powder containing a non-solid phase to deposit on a substrate surface through collision at high velocity and kinetic energy.Compared to the traditional thermal spray that relies on melting particles for coating deposition,this spray method exhibits potential advantages,such as low oxidation of the material,high bonding strength with the substrate,dense microstructure,and excellent comprehensive mechanical properties.Therefore,it has attracted extensive attention domestically and internationally in the fields of metal or metal matrix composite coatings,additive manufacturing,and the rapid repair of damaged components.First,as typical high-velocity low-temperature spray methods,cold spray,and low-temperature high-velocity oxygen-fuel spray share common characteristics:powder particles interact with the gas in the nozzle,experiencing heating and acceleration through heat transfer and the drag force of the gas.The elevated kinetic and internal energies of the particles may induce certain behaviors that have the potential to enhance interface bonding.These behaviors include fragmentation of the oxidation films,structural changes,and even localized melting upon collision with the material surface.The analysis of some studies indicates a significant influence of velocity and temperature on the material deposition behavior and the final coating performance.Subsequently,spray strategy planning and coating performance modulation can be performed,guided by the deposition window constrained by the particle velocity and temperature.The particle temperature determines the ductility during collision,thereby influencing the deformation behavior,surface morphology,flatness,material jetting behavior,and bonding quality,whereas the velocity determines the kinetic energy during collision,thereby influencing the stress and strain inside the material.The subsequent section of this paper discusses the composition of high-velocity low-temperature spray equipment systems,including the spray gun system(comprising a nozzle and gas heater),powder feeder,gas/fuel sources,spray scanning component,and control system.The structural design strategies of each major component and their influence on the gas-solid flow behavior are discussed in detail.The spray gun is the core component of the spray system,which comprises a nozzle that supplies initial kinetic energy to the gas and a gas heater that supplies initial internal energy to the gas.Under specific process conditions,the particle velocity demonstrates an initial increase followed by a decrease with the expansion length or expansion ratio of the nozzle,whereas the trend of the particle temperature is reversed.Gas heaters are primarily categorized as electric and combustion flame heaters.This serves as a crucial basis for distinguishing between cold spray and high-velocity oxygen-fuel spray.Electric heaters operate at a maximum temperature of approximately 1 300 K and are designed with intricate and convoluted airflow paths within limited volumes to maximize heating efficiency.The maximum temperature of the combustion flame can reach 3 400 K.Adjusting the type and proportion of combustion reactants,along with implementing rational cooling flow control strategies,allows for the continuous regulation of the flame temperature across a wide range.Therefore,a comprehensive approach involving the adjustment of the process parameters and spray gun structure achieves on-demand control of the particle temperature and velocity.Finally,some key issues in the high-velocity low-temperature spray process,and equipment systems are discussed.The main emphasis of this paper is to summarize the methods by which control over coating performance can be attained through the design of the spraying parameters and apparatus.This study contributes to an in-depth understanding of the deposition mechanisms in high-velocity low-temperature sprays and provides a valuable reference for the development of high-performance spray equipment systems.