Particulate Reinforced Metal Matrix Composites Prepared by Spray Forming:An Overview

SI Chao-run,ZHANG Xian-jie,WANG Jun-biao

DOI: https://doi.org/10.3969/j.issn.1001-9731.2015.01.001

2015-01-01

Abstract:Spray forming was a new developed high-performance metal forming technology,during the process of which the metal stream was firstly atomized into a spray of droplets by high-pressure gas j ets and then deposited on a substrate.After the introduction of spray forming into the preparation of metal matrix composites,several preparation methods were developed such as particulate premixed spray forming,reaction spray forming and spray deposition.The principles,characteristics,and development situations of the mentioned methods were re-viewed.Through the comparative analysis,spray deposition was a promising preparation method because of the technological feasibility and extensive adaptability.At last a self-developed spray deposition technology was in-troduced.During the progress,a gas-particulate dual-phase was used as the atomizing medium to improve the atomization efficiency and enhance the particulate distribution uniformity.