Abstract:Large enhancements of the melt strength of polypropylene (PP) were achieved by the introduction of specific unsaturated linear polyester (ULP) branches using melt grafting. The transient torque curves and optical rheology microscope images indicated that branching reactions took place and the ULP had been grafted onto the PP backbone. Shear rheological behaviors of three kinds of PP were investigated using rotational rheometer under dynamic shear mode with periodic shear rate. These PP samples are foamable PP (FPP) with sparse branches obtained by grafting ULP, commercial high melt strength PP (HMS PP) for foaming and conventional linear PP (EPS). It was found that the rheological properties of FPP, the HMS PP, were distinctly different from those of conventional PP. Storage modulus, steady state compliance and zero shear viscosity increased in comparison with EPS, while shear viscosity decreased. This result implied the presence of branching structures that was not revealed in conventional PP. In melt flow measurements, extrusion swell that was a prominent behavior of branching PP was observed also for FPP and PF. Compared to linear PP, FPP and PF showed distinct sag-resistant property and lower melt flow index. On the other hand, to estimate the extent of branching, a detailed method was applied using the obtained zero shear viscosity. The result showed that FPP was grafted by sparse ULP. From these results, it was found that FPP showed obvious enhancements in rheological behaviors similar to PF, although its melt strength was lower than that of PF due to the presence of shorter branching chains grafted on the backbone of FPP.

Research Progress on Melt Grafting of Polypropylene

Simultaneous Graft Polymerization of Polypropylene with Maleic Anhydride and Butyl Acrylate

Study on Grafting Modifying Copolymerization of Polypropylene Melt-blown Nonwoven

Nondegradative Melt Functionalization of Polypropylene with Glycidyl Methacrylate

Study on Solid Phase Grafting of Acrylic Acid onto Polypropylene to Prepare Hydrophilic Polypropylene

THE STUDY OF APPLIED BEHAVIOR OF PP/PA6 BY USING GRAFTED POLYPROPYLENE AS COMPATILIZER

Study of multi-monomer melt-grafting onto polypropylene in an extruder

Influence Of Grafting Formulations And Extrusion Conditions On Properties Of Silane-Grafted Polypropylenes

Improving Foamability of Polypropylene by Grafting Modification

Study on Melting Grafted Polypropylene with High Fluidity

Study of Melt Free Radical Grafting of Maleic Anhydride and Styrene Onto Polypropylene and Its Properties

Hydrophilic Modification of Recycled-Polypropylene

A Novel Method for Functionalization of Polypropylene with Oligomer of Glycidyl Methacrylate: Characterization of Copolymers

Synthesis of multifunctional polypropylene via solid phase cografting and its grafting mechanism

The Characterization of Rheological Properties of Melt Grafting Polypropylene for Foaming

Melt Grafting Of A Long-Chain Unsaturated Carboxylic Acid Onto Polypropylene

Study on Grafting and Modifying of Chlorinated Polypropylene

The Dielectric Properties of Polypropylene Grafting with Methyl Methacrylate

PROPERTIES OF PP-g-AA(FPP) PREPARED BY MELT-EXTRUSION AND EFFECT OF FPP ON MECHANICAL PROPERTIES OF POLYPROPYLENE

Synthesis and Characterization of A Macromolecular Surface Modifier for Polypropylene

Synthesis of Multifunctional Polypropylene Via Solid Co-Grafting and the Mechanism Study.