Abstract:On the basis of previous experimental studies of two-phase flow condensation heat transfer for R134a inside the horizontal micro-fin tubes, a theoretically analysis of heat transfer characteristic combining both heat transfer mechanism and flow mechanism is discussed by the experimental data of heat transfer coefficient and pressure drop, to further clarify the influence of experimental condition and tube structure on heat transfer characteristics under the special working condition. Two performance factors, enhancement factor (EF) and penalty factor (PF), are introduced to quantitatively compare the effect of micro-fin on the heat transfer coefficient and the pressure drop between enhance tube and smooth tube. Meanwhile, the comprehensive factor, CHF, is applied to evaluate the comprehensive performance of heat transfer tube. It was found that enhancement factor (EF) and penalty factor (PF) both increase with increasing mass flux and fin helical angle, and decreasing saturation temperature, the comprehensive factor, CHF, is always greater than one and increases with increasing fin helical angle and mass flux, and decreasing saturation temperature. Moreover, based on the comparative analysis findings that some existing correlations of heat transfer characteristics underestimate most of the experimental data, and the experimental variable has great influences on the correlation prediction accuracy, such as mass flux, which is proportionate to the prediction deviation of correlation. Therefore, a new correlation was developed through analyzing quantitatively influencing mechanism of the experimental variable on the heat transfer characteristics, in a way that a two-phase frictional multiplier is defined firstly from the experimental data and then the forced convection heat transfer mechanism is redefined based on the comprehensive effect of various experimental variables. By the experimental data verification, the new correlation shows good prediction effect with the mean deviation of less than 5%.

To Characterize Two-Phase Flows Around a Finned Tube Using the Three-Dimensional Particle Dynamics Analyzer (PDA) and Numerical Calculation

To characterize two-phase flows around finned tube by using 3D-PDA and numerical calculation

Experimental study of two-phase flow inside finned-tubes separator using 3-D-PDA

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

PHASE DETECTION AIDED THERMOMETRY AND ITS APPLICATION TO NATURAL CONVECTIVE SUBCOOLED FLOW BOILING IN A NARROW GAP

Two-Fluid Model Simulations of the National Energy Technology Laboratory Bubbling Fluidized Bed Challenge Problem

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW AROUND A SQUARE-SECTION CYLINDER BY 3D-PDPA

Numerical Study on the Flow Features of U-beam Inertial Separator

Numerical simulation of swirling gas-solid two phase flow through a pipe expansion

AN EXPERIMENTAL STUDY ON THE GAS-SOLID TWO-PHASE FLOW IN A SQUARE CYCLONE SEPARATOR WITH DOWNWARD GAS EXIT BY 3D-PDA

3D-CFD Simulation of Liquid–Liquid Two-Phase Flow in A Pilot-Plant Scale Annular Pulsed Disc and Doughnut Column

Turbulent Flow Calculation in Non-Orthogonal Curvilinear Co-Ordinates and Its Measurement by PDA in a Model Furnace

Numerical simulation of gas-liquid two-phase turbulent flows through a centrifugal impeller

Experimental and numerical investigation on flow and heat transfer characteristics of a multi-waves internally spiral finned tube

Numerical Simulation and Experimental Study of Two-Phase Flow in a Vertical Pipe

STUDY ON TURBULENCE MODULATION OF GAS-SOLID TWO-PHASE FLOW IN A SUDDEN-EXPANSION TUBE

Numerical Study of the Hydrodynamics Properties of U-Beam Inertial Separator

Numerical Investigations of Solid-Liquid Two-Phase Turbulent Flows through Francis Turbine

Experimental study of two-phase flow structure in churn-turbulent to annular flows

Numerical Simulation Studies on Multiphase Flow in High Temperature Wind Tunnel Contractions and Experimental Sections