Abstract:Dynamic crack propagation in brittle materials plays an important role in understanding the fracture mechanism. Numerical simulations on crack propagation in the polymethyle methacrylate (PMMA) under explosive loads were carried out through Autodyn 3D code. Although the Johnson-Holmquist (JH-2) constitutive model has been widely treated as an acceptable scheme, it cannot improve the description in the post-failure response of material and reduce the mesh dependency, so the crack softening failure model are introduced in our present work based on two failure criterions. First, material parameters of JH-2 model, failure criterion, and crack softening failure model are determined from available data and calculations. The circular and rectangle thin plates are modeled to explore the fracture mechanisms for single-borehole and dual-borehole explosions. The simulation results well reproduced the entire dynamic evolutionary process of the crushed and fractured zones, crack initiation, propagation and arrest as well as secondary propagation, which successfully proved the reliabilities of the combination of JH-2 constitutive model, failure criterion, and crack softening failure model and corresponding material parameters. For dual-borehole explosion, the crack linkage is well performed when borehole distance L is 20 and 30 cm; cracks are failed to link with each other at L = 40 cm although main cracks have arrived into the opposite fractured zone. More importantly, it is found that the crack linkage mainly depends on L , which has an important effect on linkage style and its location. Despite a larger L makes more difficult in crack linkage, this difficulty lies not in the shortage of crack length, but in losing control of directional fracture of cracks between two boreholes.

Experimental Study on the Path of Crack Growth of Elastic-plastic Materials'Dynamic Fracture

Experimental Study on the Dynamic J-Resistance Curve of Crack Growth of Elastic-Plastic Materials

Experimental studies on dynamic fracture behavior of thin plates with parallel single edge cracks

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Elastic–plastic finite element analysis and experimental study of short and long fatigue crack growth

Dynamic Crack Growth in a Fiber-Reinforced Composite Plate

New double-k criterion for crack propagation in quasi-brittle fracture under moderate dynamic loading: Experimental investigation

Study of the effect of lengths on the propagation mechanism of interconnected cracks under impact loads

Experimental investigations of the dynamic mechanical properties and fracturing behavior of cracked rocks under dynamic loading

Experimental study of dynamic fracture behavior of PMMA with overlapping offset-parallel cracks

Experimental Investigation of Dynamic Fracture Behaviors of Polymethyl Methacrylate

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Investigation on the Deformation and Failure Characteristics of Concrete in Dynamic Splitting Tests

Experimental study on the energy evolution law during crack propagation of cracked rock mass under impact loads

Study on Microcrack Growth-Based Dynamic Compressive Mechanical Properties in Brittle Rocks

Experimental and numerical investigation of crack propagation and dynamic properties of rock in SHPB indirect tension test

Elastic-Plastic Finite Element Analysis of the Effect of the Compressive Loading on the Crack Tip Plasticity

Numerical study on crack propagation under explosive loads

Crack Velocity- and Strain Rate- Dependent Dynamic Compressive Responses in Brittle Solids

A Micro–macro Method for Evaluating Progressive and Direct Tensile Fractures in Brittle Rocks

Dynamic Tracking of Cracking Progress of Elastic Body by DDM