Abstract:Torrefaction is a low-temperature process considered as an effective pretreatment technique to improve the grindability of biomass as well as enhance the production of aromatic hydrocarbons from Catalytic Fast Pyrolysis (CFP). This study was performed to understand the effect of torrefaction temperature on structural changes in the lignin macromolecule and its subsequent influence on in-situ CFP process. Lignin extracted from southern pine and switchgrass (via organosolv treatment) was torrefied at four different temperatures (150, 175, 200 and 225 degrees C) in a tubular reactor. Between the two biomass types studied, lignin from pine appeared to have greater thermal stability during torrefaction when compared with switchgrass lignin. The structural changes in lignin as a result of torrefaction were followed by using FTIR spectroscopy, solid state CP/MAS C-13 NMR, P-31 NMR spectroscopy and it was found that higher torrefaction temperature (200 and 225 degrees C) caused polycondensation and de-methoxylation of the aromatic units of lignin. Gel permeation chromatography analysis revealed that polycondensation during torrefaction resulted in an increase in the molecular weight and polydispersity of lignin. The torrefied lignin was subsequently used in CFP experiments using H(+)ZSM-5 catalyst in a micro-reactor (Py-GC/MS) to understand the effect of torrefaction on the product distribution from pyrolysis. It was observed that although the selectivity of benzene-toluene-xylene compounds from CFP of pine improved from 58.3% (torrefaction temp at 150 degrees C) to 69.0% (torrefaction temp at 225 degrees C), the severity of torrefaction resulted in a loss of overall aromatic hydrocarbon yield from 11.6% to 4.9% under same conditions. Torrefaction at higher temperatures also increased the yield of carbonaceous residues from 63.9% to 72.8%. Overall, torrefying lignin caused structural transformations in both type of lignins (switchgrass and pine), which is ultimately detrimental to achieving a higher aromatic hydrocarbon yield from CFP. (C) 2016 Elsevier B.V. All rights reserved.

The Solid Residue and liquid Products of Paulownia Direct Liquefaction Analyzed With FTIR

Infrared Spectrum Analysis of the Direct Catalytic Liquefaction Products of Paulownia

Experimental Research on the Direct Liquefaction of Paulownia in Water to Make Bio-oil

Research on Iron Catalyst by the Direct Liquefaction of Paulownia in Water

Structure-property Relationships for Technical Lignins for the Production of Lignin-Phenol-formaldehyde Resins

FT-IR and tga studies on liqufied wood products in the condensation reaction process

Phosphoric Acid Catalyzed Liquefaction of Acacia Mangium Bark and Resinification of Liquefied Products

Influence of temperature, residence time, and solvent/feedstock mass ratio on overall product distribution and oil products quality in ethanol liquefaction of 230 polypropylene impact copolymer

Effect of Torrefaction Temperature on Lignin Macromolecule and Product Distribution from HZSM-5 Catalytic Pyrolysis

Comparison of the Pyrolysis Behavior of Pyrolytic Lignin and Milled Wood Lignin by Using TG–FTIR Analysis

Investigation of liquefied wood residues based on cellulose, hemicellulose, and lignin

The Pyrolysis Behaviors of Blended Pellets of Pine Wood and Urea-Formaldehyde Resin

Comparative study of liquefaction process and liquefied products from bamboo using different organic solvents

The pyrolytic degradation of wood-derived lignin from pulping process

Study on Gas Products Distributions During Fast Co-Pyrolysis of Paulownia Wood and PET at High Temperature

Relationship of Thermal Degradation Behavior and Chemical Structure of Lignin Isolated from Palm Kernel Shell under Different Process Severities

Study on Mechanisms of Liquefied Corn Bran by FT-IR

Mild Liquefaction Behavior of Lignocellulosic Material Components

Characterization of lignocellulosic biomass thermal degradation and physiochemical structure: Effects of demineralization by diverse acid solutions

Pyrolysis Characteristics, Gas Products, Volatiles, and Thermo–kinetics of Industrial Lignin Via TG/DTG–FTIR/MS and In–situ Py–PI–TOF/MS

Comprehensive evaluation of hydro-liquefaction characteristics of lignocellulosic subcomponents