Abstract:Sm0.2Ce0.8O1.9 (SDC)-impregnated La0.7Sr0.3MnO3 (LSM) composite cathodes were fabricated on anode-supported yttria-stabilized zirconia (YSZ) thin films. Electrochemical performances of the solid oxide fuel cells (SOFCs) were investigated in the present study. Four single cells, i.e., Cell-1, Cell-2, Cell-3 and Cell-4 were obtained after the fabrication of four different cathodes, i.e., pure LSM and SDC/LSM composites in the weight ratios of 25/75, 36/64 and 42/58, respectively. Impedance spectra under open-circuit conditions showed that the cathode performance was gradually improved with the increasing SDC loading. Similarly, the maximum power densities (MPD) of the four cells were increased with the SDC amount below 700°C. Whereas, the cell performance of Cell-4 was lower than that of Cell-3 at 800°C, arising from the increased concentration polarization at high current densities. This was caused by the lowered porosity with the impregnation cycle. This disadvantage could be suppressed by lowering the operating temperature or by increasing the oxygen concentration at the cathode side. The ratio of electrode polarization loss in the total voltage drop versus current density showed that the cell performance was primarily determined by the electrode polarization. The contribution of the ohmic resistance was increased when the operating temperature was lowered. When a 100mlmin−1 oxygen flow was introduced to the cathode side, Cell-3 produced MPDs of 1905, 1587 and 1179mWcm−2 at 800, 750 and 700°C, respectively. The high cell outputs demonstrated the merits of the novel and effective SDC-impregnated LSM cathodes.

Microstructures and Interfacial Resistance of Lsm-Sdc Composite Cathodes for It-Sofcs

Fabrication of LSM-SDC Composite Cathodes for Intermediate-Temperature Solid Oxide Fuel Cells

Sol-gel derived composites as cathodes for solid oxide fuel cells

Intermediate temperature solid oxide fuel cell composite cathodes consisting of nanostructured LSM and SDC particles

LSM–SDC electrodes fabricated with an ion-impregnating process for SOFCs with doped ceria electrolytes

Improved Thermal Expansion and Electrochemical Performance of La0.4Sr0.6Co0.9Sb0.1O3--Ce0.8Sm0.2O1.9 Composite Cathode for IT-SOFCs

Electrochemical Characteristics of Lscf-Sdc Composite Cathode for Intermediate Temperature Sofc

Electrochemical Characterization of LaBaCuCoO5+δ–Sm0.2Ce0.8O1.9 Composite Cathode for Intermediate-Temperature Solid Oxide Fuel Cells

Effect of Sdc-Impregnated Lsm Cathodes on the Performance of Anode-Supported Ysz Films for Sofcs

Performance of La 0.5 Sr 0.5 Fe 0.9 Mo 0.1 O 3 − δ –Sm 0.2 Ce 0.8 O 2 − δ composite cathode for CeO 2 - and LaGaO 3 -based solid oxide fuel cells

Semiconductor-Ionic Nanocomposite La0.1Sr0.9MnO3−δ-Ce0.8Sm0.2O2−δ Functional Layer for High Performance Low Temperature SOFC

Effect of firing temperature on the performance of LSM–SDC cathodes prepared with an ion-impregnation method

Preparation and Performance Study of One-Dimensional Nanofiber-Based Sm0.5Sr0.5CoO3-δ-Gd0.2Ce0.8O1.9 Composite Cathodes for Intermediate Temperature Solid Oxide Fuel Cells

Composite Electrolyte Based On Nanostructured Ce0.8sm0.2o1.9 (Sdc) For Low-Temperature Solid Oxide Fuel Cells

Effect of Electrolyte Surface Microstructure on Interfacial Polarization Resistances of Solid Oxide Fuel Cell Cathodes

Co‐synthesis of Sm0.5Sr0.5CoO3‐Sm0.2Ce0.8O1.9 Composite Cathode with Enhanced Electrochemical Property for Intermediate Temperature SOFCs

Nanofiber-structured SSC–GDC Composite Cathodes for a LSGM Electrolyte Based IT-SOFCs

Electrochemical Evaluation of La0.6Sr0.4Co0.8Fe0.2O3−δ–La0.9Sr0.1Ga0.8Mg0.2O3−δ Composite Cathodes for La0.9Sr0.1Ga0.8Mg0.2O3−δ Electrolyte SOFCs

Electrical and Stability Performance of Anode-Supported Solid Oxide Fuel Cells with Strontium- and Magnesium-Doped Lanthanum Gallate Thin Electrolyte

Preparation and Electrochemical Properties of La0.7Sr0.3FeO3-Sm0.2Ce0.8O3 Composite Cathodes

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)