Abstract:As a common hazard, coal spontaneous combustion (CSC) causes the loss of coal in piles and mines. To rapidly and reliably forecast CSC, a portable and powerful detection system based on a laser spectroscopic technique is proposed, to precisely measure gaseous inhibitors; the technique uses a single, distributed-feedback diode laser emitting at 2.33 mu m as a sensing light source for dual species. The detection system carries out wavelength-modulation spectroscopy to suppress detection noise by using a two-channel analogue lock-in amplifier (ALIA) and a complex programmable logic device (CPLD) controller. To improve detection sensitivity, a Herriott cell is adopted to increase the interaction length between the laser and the target species. The embedded system on a chip (SoC) of STM32F103 is the charge of the current driver and temperature control of the laser. Deployment of the SoC of STM32H743 acquires and digitally filters the original demodulated absorption signal, after which communication with a personal computer takes place. The second demodulation component, normalized by the first demodulation component, is used to improve the signal-to-noise ratio. The sensor-calibration experiment reveals the square of the correlation coefficients R-2 to be 0.99718 and 0.99905 for carbon monoxide (CO) and methane (CH4), respectively, over the concentration range of 5-200 ppm. Using Allan-Werle deviation analysis, the detection sensitivity for CO and CH4 are 0.27 ppm and 0.20 ppm with a 2.5 s sampling time, and 0.05 ppm and 0.03 ppm with similar to 125 and 95 s integration times, respectively. Finally, the detection system is used for the online measurement and analysis of the growth pattern of gaseous products which are released during the CSC process, the temperature varying from 30 to 200 degrees C. Two critical temperatures were correctly determined to further forecast CSC status. On beginning a vigorous oxidation process, the exponential-evolution trends of the CH4 and CO gases agree with each other. Compared with CH4, CO may be more suitable for online, early detection of CSC.

Intrinsic Safety Explosion-Proof System Monitoring Oxygen Concentrations in Coke-Oven Gas

Design of Portable Quantitative Detectors for Methane Based on MSP430

On-Line Safety Monitoring Of Explosive Gas Concentration For Process In Bf

A temperature-compensated CO2 detection system based on non-dispersive infrared spectral technology

Near-infrared wide-range dual-gas sensor system for simultaneous detection of methane and carbon monoxide in coal mine environment

Wireless Oxygen Content Monitor Design in Metallurgy Gas Processing

Early Detection System for Coal Spontaneous Combustion by Laser Dual-Species Sensor of CO and CH4

A Distributed IoT Air Quality Measurement System for High-Risk Workplace Safety Enhancement

Design and Implementation of an Early-Stage Monitoring System for Iron Sulfides Oxidation

Miniature low-power IR monitor for methane detection

Environmental oxygen monitoring in confined spaces by a mobile sensor system based on OA-ICOS and PSO-SVM without pressure control

High Performance Colorimetric Carbon Monoxide Sensor for Continuous Personal Exposure Monitoring.

Experimental Study on the Isolation Effect of an Active Flame-Proof Device on a Gas Explosion in an Underground Coal Mine

Design of Toxic Environment Monitoring System for Industrial Sites Based on Wireless Sensor Networks

On line monitoring technology of trace CO volume fraction at the outlet of coal mill based on TDLAS and constant-flow dilution sampling

Development of a Graded Early Warning Index System and Identification of Critical Temperatures for Coal Spontaneous Combustion Using Composite Gas Characteristics

Design and Research of Mine Toxic Gas Monitoring and Early Warning Sensor Based on Multi-Purpose

Design of Laboratory Fire Safety Monitoring System

CO Detection System Based on TDLAS Using a 4.625 μm Interband Cascaded Laser

Study on the Development of the Medium-Scale Gas Explosion Integrated Testing System

The design of an indoor carbon monoxide safety monitor system based on a single chip computer