Abstract:As a common hazard, coal spontaneous combustion (CSC) causes the loss of coal in piles and mines. To rapidly and reliably forecast CSC, a portable and powerful detection system based on a laser spectroscopic technique is proposed, to precisely measure gaseous inhibitors; the technique uses a single, distributed-feedback diode laser emitting at 2.33 mu m as a sensing light source for dual species. The detection system carries out wavelength-modulation spectroscopy to suppress detection noise by using a two-channel analogue lock-in amplifier (ALIA) and a complex programmable logic device (CPLD) controller. To improve detection sensitivity, a Herriott cell is adopted to increase the interaction length between the laser and the target species. The embedded system on a chip (SoC) of STM32F103 is the charge of the current driver and temperature control of the laser. Deployment of the SoC of STM32H743 acquires and digitally filters the original demodulated absorption signal, after which communication with a personal computer takes place. The second demodulation component, normalized by the first demodulation component, is used to improve the signal-to-noise ratio. The sensor-calibration experiment reveals the square of the correlation coefficients R-2 to be 0.99718 and 0.99905 for carbon monoxide (CO) and methane (CH4), respectively, over the concentration range of 5-200 ppm. Using Allan-Werle deviation analysis, the detection sensitivity for CO and CH4 are 0.27 ppm and 0.20 ppm with a 2.5 s sampling time, and 0.05 ppm and 0.03 ppm with similar to 125 and 95 s integration times, respectively. Finally, the detection system is used for the online measurement and analysis of the growth pattern of gaseous products which are released during the CSC process, the temperature varying from 30 to 200 degrees C. Two critical temperatures were correctly determined to further forecast CSC status. On beginning a vigorous oxidation process, the exponential-evolution trends of the CH4 and CO gases agree with each other. Compared with CH4, CO may be more suitable for online, early detection of CSC.

Near-infrared wide-range dual-gas sensor system for simultaneous detection of methane and carbon monoxide in coal mine environment

A temperature-compensated CO2 detection system based on non-dispersive infrared spectral technology

Early Detection System for Coal Spontaneous Combustion by Laser Dual-Species Sensor of CO and CH4

Research on Multi-point Measurement System of Mine Gas Based on TDLA

A Non-Source Optical Fiber Sensor for Multi-Point Methane Detection

A multiline fitting method for measuring ethylene concentration based on WMS-2f/1f

Near-Infrared Dual-Range Methane Sensor Using the OAIC-HC Mode Based on VMD-SG-Assisted Optical Noise Suppression

Hard-Target Reflection Laser Spectroscopy of Carbon Monoxide Gas Concentration for the Early Detection of Spontaneous Combustion of Coal

Optically powered gas monitoring system using single-mode fibre for underground coal mines

Experimental Study on Spontaneous Combustion Monitoring in Coal Mine Airspace Based on Distributed Fiber Optic Temperature Measurement

A calibration-free carbon monoxide sensor based on TDLAS technology

Frequency division multiplexing and wavelength stabilized 2f/1f wavelength modulation spectroscopy for simultaneous trace CH4 and CO2 detection

Design and Research of Mine Toxic Gas Monitoring and Early Warning Sensor Based on Multi-Purpose

Tunable Diode Laser Absorption Spectroscopy for Open-Path Monitoring Gas Markers in Fire Combustion Products

Simultaneous atmospheric CH 4 , CO 2 and O 2 detection using fiber-optic switch (FOS)-based time-division multiplexed NIR laser long optical path absorption spectroscopy

Study on Online Detection Method of Methane Gas in Coal Mine Based on TDLAS Technology

CH4/C2H6 dual gas sensing system using a single mid-infrared laser

Methane Sensors Based on Lithium Doped Porous Materials for Coal Mine Safety Application

Low-cost quartz tuning fork based methane sensor for coal mine safety applications

Study of CH4 Detection Method Based on Mid-IR LED

A baseline correction and noise suppression method based on fitting neural network for CH4/C2H6 dual gas sensing system