Abstract:Growing attention is being directed towards exploring the potential harmful effects of microplastic (MP) particles on human health. Previous reports on human exposure to MPs have primarily focused on inhalation, ingestion, transdermal routes, and, potentially, transplacental transfer. The intravenous transfer of MP particles in routine healthcare settings has received limited exploration in existing literature. Standard hospital IV system set up with 0.9 % NaCl in a laminar flow hood with MP contamination precautions. Various volumes of 0.9 % NaCl passed through the system, some with a volumetric pump. Fluid filtered with Anodisc filters washed with isopropyl alcohol. The IV cannula was immersed in Mili-Q water for 72 h to simulate vein conditions. Subsequently, the water was filtered and washed. Optical photothermal infrared (O-PTIR) microspectroscopy is used to examine filters for MP particles. All filters examined from the IV infusion system contained MP particles, including MPs from the polymer materials used in the manufacture of the IV delivery systems (polydimethylsiloxane, polypropylene, polystyrene, and polyvinyl chloride) and MP particles arising from plastic resin additives (epoxy resin, polyamide resin, and polysiloxane-containing MPs). The geometric mean from the extrapolated result data indicated that approximately 0.90 MP particles per mL of 0.9 % NaCl solution can be administered through a conventional IV infusion system in the absence of a volumetric pump. However, with the implementation of a pump, this value may increase to 1.57 particles per mL. Notably, over 72 h, a single cannula was found to release approximately 558 MP particles including polydimethylsiloxane, polysiloxane-containing MPs, polyamide resin, and epoxy resin. Routine IV infusion systems release microplastics. MP particles are also released around IV cannulas, suggesting transfer into the circulatory system during standard IV procedures.

Investigation on Shedding and Filtering of Particles from Filter in Disposable Infusion Apparatus

STUDY ON WASHING METHOD OF MEDICAL APPARATUS AND INSTRUMENT

Studies on Particulate Matter in Intravenous Admixture

Performance of Microbiological Control by A Point-Of-Use Filter System for Drinking Water Purification

Advanced optical photothermal infrared spectroscopy for comprehensive characterization of microplastics from intravenous fluid delivery systems

Study of Insoluble Particles and Microorganism Contamination Produced by Clinical Use of Plastic and Glass Ampoules

Theoretical and Experimental Investigations of Time-Dependent Mass Transfer Mechanism of Fine Particulate Matter under the Sink Effect

An investigation of the filtration performance and mechanism of oil-solid mixed particles on filter materials with different wettability

Passage and community changes of filterable bacteria during microfiltration of a surface water supply

Removal of Cryptosporidium sized particle under different filtration temperature, flow rate and alum dosing

Construction and Investigation of a Filtration Efficiency Test System for High-Efficiency Filter Materials Based on Mass Concentration

Research note: Pressure drop and penetration for pre-charged and neutral particles on fibrous and membrane filters

Streamline-based Purification of Bacterial Samples from Liquefied Sputum Utilizing Microfluidics

Is It the Appropriate Syringe Filter? the Loss of PPCPs During Filtration by Syringe Filter

Numerical investigation of non-spherical particle deposition characteristics on filter media

Disposable microporous membrane filter

Development and Design of Water Surface Type Filtration and Sterilization Device

Examination of Particulate Contamination in Parenteral Injections and Infusions Following Fluid Withdrawal Utilizing Conventional Needles and Filter Needles: Assessment of Compliance and Comparative Analysis

Method for determination and element analysis of particulate contamination in injectable solutions

Collection of Nanoparticles at the Air-Liquid Interface by Surface Tension Gradients

Loss of micropollutants on syringe filters during sample filtration: Machine learning approach for selecting appropriate filters