Abstract:Ventilation and air distribution systems for cleanrooms in electronic industry have been overdesigned. Reducing the air supply volume of fan filter units (FFUs) is considered an energy saving measure. However, little is known about the particle removal performances after reduction in air supply volume. In this study, experiments were conducted in a chamber to investigate the effects of reducing air supply volume on the characteristic of particle distribution. The experiments were based on three FFU speed ratios (80%, 50%, and 40%) and four particle source locations (source in the subzone with and without an FFU at the heights of 1.5 m and 1.0 m) at two FFU area ratios (50% and 25%). The results were analyzed using the dimensionless particle concentrations (with respect to ideal mixing condition) in sixteen subzones within the experimental region. It was concluded that (1) the containment effect of air distribution on particle lateral dispersion was weakened with the decrease of air supply volume for FFU area ratios of both 50% and 25%; (2) most subzones have been well protected at an FFU area ratio of 50% (with dimensionless concentrations far below 0.2) regardless of the source location, and at an FFU area ratio of 25% (with dimensionless concentrations far below 0.5) for the particle source under an FFU supply airflow. However, the containment effect has been poor at an FFU area ratio of 25% for the particle source not under an FFU supply airflow regardless of the air supply volume; (3) the working face at a height of 1.0 m was slightly more affected for a source height of 1.5 m compared with a source height of 1.0 m at an FFU area ratio of 50%, while there was no significant difference in the particle removal for both source heights at an FFU area ratio of 25%; and (4) the air supply volume could be reduced by 46.7% (0.2 as the critical value) and 43.8% (0.5 as the critical value), respectively for FFU area ratios of 50% and 25% from the perspective of air distribution effectiveness. This study improves the understanding of characteristics of reduced airflow in cleanrooms.

Boundary conditions for perforated inlet panels in simulations of airflow inside clean rooms

Flow and Heat Transfer Analysis of Perforated Fin in Compact Heat Exchanger

Indoor Airflow and Pollutant Spread Inside the Cleanroom with Micro-Porous Supplying Panel and Different Ventilation Schemes: Analytical, Numerical and Experimental Investigations

Experimental and CFD Airflow Studies of a Cleanroom with Special Respect to Air Supply Inlets

Study of Influence of Boundary Condition of Diffuser with Non-Uniform Velocity on the Jet Characteristics and Indoor Flow Field

Analysis and Experiments on the Characteristics of Airflow and the Air Cleanliness Protection Region under Fan Filter Units in Cleanrooms

Theoretical expression for clean air volume in cleanrooms with non-uniform environments

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Numerical Investigation on the Effects of Gap Circulating Flow on Blower Performance under Design and Off-Design Conditions

Experimental study of the factors influencing the uniformity of an air curtain and numerical simulation of the factors influencing its dust barrier effect

Numerical Analysis about the Flow Pattern Resulted by Exhaust Air and Supply Air

Experimental Investigation of Particle Dispersion in Cleanrooms of Electronic Industry under Different Area Ratios and Speeds of Fan Filter Units

A simplified system for indoor airflow simulation

Regional flow motion and heat energy balance analysis of a 10,000 class pharmaceutical cleanroom with secondary return air conditioning system

Influence of inlet and outlet conditions on flow characteristics of a perforated plate

Simulation on interface airflow by occupant's traffic flow through operating room

A Compatible Inlet Condition for Simulation of Supersonic Reacting Mixing Layers

Numerical simulation of air distribution in chair ventilated rooms by simplified methodology

Modeling the performance of air filters for cleanrooms using lattice Boltzmann method

Impact of the Speed of Airflow in a Cleanroom on the Degree of Air Pollution

Large Eddy Simulation of Flow Field in Vector Flow Clean-Room