Abstract:The active dynamic vibration absorber (AVA) is widely used for broadband frequency vibration reduction. A coil-magnet electrodynamic AVA with moving magnetic circuits is presented in this work. In cases where there is little height difference between the mover and stator, the magnetostatic force with the characteristic of "positive stiffness" generated by the moving permanent magnet can result in an increase in the fundamental frequency of the AVA, consequently affecting its working frequency range and controllability. The auxiliary yokes are introduced to reduce the electromagnetic stiffness of the designed AVA, ensuring that its fundamental frequency is solely determined by the mechanical stiffness provided by the spring leaf. Two optimization objectives suitable for the dynamic output force optimization of the AVA are presented, specifically maximizing the average electromagnetic force and minimizing the fluctuation of the electromagnetic force. Subsequently, a multi-objective optimization design approach is proposed based on the surrogate modeling technique and an improved non-dominated sorting genetic algorithm-II with preference. A compromise solution is selected from the Pareto solution set, and the electromagnetic force of the model after optimization is compared with those of the initial structure which is not optimized. The optimization results proved that the average electromagnetic force is increased by 9.0% and an 8.0% reduction in its fluctuation. Next, the experiment on output characteristics is performed to determine the working frequency range from 40 to 180 Hz. Within this interval, the output force is frequency-independent and directly proportional to the magnitude of the input signal. Finally, utilizing a vibration control algorithm yields attenuations of 26.6 dB at 66 Hz and 49.7 dB at 158 Hz. The feasibility and effectiveness of the AVA for broadband vibration suppression are validated.

Optimization of Active Dynamic Vibration Absorber Based on Genetic Algorithm and LQR

Optimization of Feedback Parameters of Active Vibration Control System with Genetic Algorithm

An Adaptive Feedback Vibration Control Algorithm

Research on Frequency-Selective Output Constraint Algorithm for Active Vibration Control

State Space Lqg-Based Active Microvibration Control Of Micro-Manufacturing Platform

Active suspension LQR control based on modified differential evolutionary algorithm optimization

Vibration Suppression of Hub Motor-Air Suspension Vehicle

Joint Control of Multiple Adaptive Tuned Vibration Absorbers Based on Magnetorheological Elastomers

Design and Experimental Research on Active Control System of Low Frequency Vibration

Adaptive Tuned Vibration Absorber Based on Magnetorheological Elastomers and Its Optimal Control

H∞ Optimization of Three-Element-Type Dynamic Vibration Absorber with Inerter and Negative Stiffness Based on the Particle Swarm Algorithm

Optimizations of distributed dynamic vibration absorbers for suppressing vibrations in plates

On the Design of Adaptive Active Resonant Vibration Absorber and its Vibration Damping Effect

Research on Location Optimization of Seismic Reduction Device Based on Improved Genetic Algorithm

Genetic Algorithms Optimization Design of Lower Order H∞ Controller for Vibration Systems

Optimal design of a coil-magnet electrodynamic active dynamic vibration absorber to enhance the controllability of dynamic output force

Optimization of Engine Cooling Module Vibration Based on a Genetic Algorithm

Study of Adaptive Tuned Vibration Absorber and Its Dynamic Properties

Vibration control enhancement in a full vehicle dynamic model by optimization of the controller's gain parameters

A Co-Optimization Method of Actuators/Sensors Placement and LQG Controller for Vibration Suppression

Active Vibration Control for A Rotor System Subjected to Random Excitation