Abstract:The active dynamic vibration absorber (AVA) is widely used for broadband frequency vibration reduction. A coil-magnet electrodynamic AVA with moving magnetic circuits is presented in this work. In cases where there is little height difference between the mover and stator, the magnetostatic force with the characteristic of "positive stiffness" generated by the moving permanent magnet can result in an increase in the fundamental frequency of the AVA, consequently affecting its working frequency range and controllability. The auxiliary yokes are introduced to reduce the electromagnetic stiffness of the designed AVA, ensuring that its fundamental frequency is solely determined by the mechanical stiffness provided by the spring leaf. Two optimization objectives suitable for the dynamic output force optimization of the AVA are presented, specifically maximizing the average electromagnetic force and minimizing the fluctuation of the electromagnetic force. Subsequently, a multi-objective optimization design approach is proposed based on the surrogate modeling technique and an improved non-dominated sorting genetic algorithm-II with preference. A compromise solution is selected from the Pareto solution set, and the electromagnetic force of the model after optimization is compared with those of the initial structure which is not optimized. The optimization results proved that the average electromagnetic force is increased by 9.0% and an 8.0% reduction in its fluctuation. Next, the experiment on output characteristics is performed to determine the working frequency range from 40 to 180 Hz. Within this interval, the output force is frequency-independent and directly proportional to the magnitude of the input signal. Finally, utilizing a vibration control algorithm yields attenuations of 26.6 dB at 66 Hz and 49.7 dB at 158 Hz. The feasibility and effectiveness of the AVA for broadband vibration suppression are validated.

Optimal design of a coil-magnet electrodynamic active dynamic vibration absorber to enhance the controllability of dynamic output force

Exact Solutions for a Novel H<sub>2</sub> Optimal Design of Electromagnetic Tuned Mass Damper

Dynamic Characteristics and Modeling of A New Magnetorheological Damper for Broadband Vibration Control

Integrated Dynamic Characteristics and Application in Semi-Active Dynamic Absorber of Magneto-Rheological Fluids

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

The design of an active-adaptive tuned vibration absorber based on magnetorheological elastomer and its vibration attenuation performance

Adaptive Tuned Vibration Absorber Based on Magnetorheological Elastomers and Its Optimal Control

Self-learning vibration absorber with negative electromagnetic stiffness for variable vibration

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

H∞ Optimization of a Novel Maxwell Dynamic Vibration Absorber with Lever, Inerter, and Grounded Stiffness

Active-Adaptive Vibration Absorbers and its Vibration Attenuation Performance

Vibration Suppressing with Mixed Weight for Multi-Targets in Active Magnetic Bearing-Flexible Rotor System

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

H∞ Optimization of Three-Element-Type Dynamic Vibration Absorber with Inerter and Negative Stiffness Based on the Particle Swarm Algorithm

On the Design of Adaptive Active Resonant Vibration Absorber and its Vibration Damping Effect

Application of Magnetorheological Elastomer to Vibration Absorber

Development of a mechanical semi-active vibration absorber

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Vibration Suppression of Base-Excited Rotors Supported by Active Magnetic Bearings Based on an Augmented Kalman Compensator

Study of Adaptive Tuned Vibration Absorber and Its Dynamic Properties

Theoretical and experimental investigations on semi-active quasi-zero-stiffness dynamic vibration absorber