Abstract:Background:The digital to analog converter (DAC) used in space-borne electronic system is unavoidable to be affected by the radiation, and it is essential to evaluate the DAC performance before formal application. Purpose:This study aims to develop an automatic measurement system of high-accuracy and high-speed for radiation-tolerance evaluation of space-borne D/A converters.Methods:Based on the peripheral component interconnection extensions for instrumentation (PXI), Kelvin (4-wire) method and mean filtering algorithm are applied to accurately monitor the voltage and current of the DAC chip, and a switch matrix configured in software is adopted to automatically switch over measurements of different parameters. Meanwhile the PXI bus synchronization and trigger mode control are used to achieve high-speed response among modular instruments, and the cubic spline algorithm is performed to accurately extract the single event saturated cross section and linear energy transfer threshold.Results:The identified voltage precision is 0.1μV, and the DAC monitoring precision is up to 24 bit. In single event effects evaluation, the monitoring frequency of current variation and register upset are 50 Hz and 100Hz respectively, and for total dose effect evaluation, only 8-s ergodic time are needed to measure all characteristic parameters.Conclusion:The designed measurement system can evaluate the performance of space-born DAC fully automatically and efficiently with high precision, which is a reference solution to such similar research.

Suppression of Spectral Leakage in ADC Testing

Low power design for 14-bit 100MSPS pipelined ADC

ADC design in anti-jamming spread spectrum receivers

A Parasitic Elimination Bootstrapped Switch and a Fast Settling Residual Amplifier for High-Speed and High-Resolution Pipelined ADC

A sample and hold circuit for high speed ADCs

Development of radiation tolerance evaluation and measurement system for spaceborne D/A converter

Mitigating Sampling Noise for Energy-Efficient ADCs: A Tutorial Brief

Analysis of Test Result of Analog-to-Digital Converter Based on Overlapping of Output Data

Research on Analog-to-Digital Converter (ADC) Dynamic Parameter Method Based on the Sinusoidal Test Signal

ADC Dynamic Parameter Testing Scheme Under Relaxed Conditions

ADC Parameter Test Based on Improved Maximum Likelihood Estimation

ADC test methods using an impure stimulus: A survey

Improving Source-Follower Buffer For High-Speed Adc Testing

Improved Determination of the Best Fitting Sine Wave in ADC Testing

Testing development for ADC on automatic test system

High precision low-frequency AC signal source for ADC dynamic performance test system

Windows for ADC dynamic testing via frequency-domain analysis

A/D Converter INL and DNL Estimation with a Distorted Sinusoidal Stimulus Signal

Full information ADC test procedures using sinusoidal excitation, implemented in MATLAB and LabVIEW

Decreasing the Sensitivity of ADC Test Parameters by Means of Wobbling