Abstract:To investigate the safe, stable, and economically viable operation of a boiler under ultra-low-load conditions during the deep peaking process of coal-fired units, a numerical simulation study was conducted on a 660 MW front- and rear-wall hedge cyclone burner boiler. The current research on low load conditions is limited to achieving stable combustion by adjusting the operating parameters, and few effective boiler operating parameter predictions are given for very low-load conditions, i.e., below 20%. Various burner operation modes under ultra-low load conditions were analyzed using computational fluid dynamics (CFDs) methods; this operation was successfully tested with six types of pulverized coal combustion in this paper, and fitting models for outlet flue gas temperature and NOx emissions were derived based on the combustion characteristics of different types of pulverized coal. The results indicate that under 20% ultra-low-load conditions, the use of lower burners leads to a uniform temperature distribution within the furnace, achieving a minimum NOx emission of 112 ppm and a flue gas temperature of 743 K. Coal type 3, with the highest carbon content and a calorific value of 22,440 kJ/kg, has the highest average section temperature of 1435.76 K. In contrast, coal type 1 has a higher nitrogen content, with a maximum cross-sectional average NOx concentration of 865.90 ppm and an exit NOx emission concentration of 800 ppm. The overall lower NOx emissions of coal type 3 are primarily attributed to its reduced nitrogen content and increased oxygen content, which enhance pulverized coal combustion and suppress NOx formation. The fitting models accurately capture the influence of pulverized coal composition on outlet flue gas temperature and NOx emissions. This control strategy can be extended to the stable combustion of many kinds of coal. For validation, the fitting error bar for the predicted outlet flue gas temperature based on the elemental composition of coal type 6 was 8.09%, whereas the fitting error bar for the outlet NOx emissions was only 1.45%.

Numerical Study of Pulverized Coal Combustion and Optimization of Air Distrbution in a Boiler with 135 t/h

Numerical Investigation on Oxy-Combustion Characteristics of a 200 MWe Tangentially Fired Boiler

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Impact of Coal Types and Pulverizing Methods on the Thermal Performance of Blending Coal-Fired Boilers and Their Operational Optimization

Numerical Simulations Of Combustion Optimizaiton For A 600 Mw Tengentially Coal-Fired Super-Critical Boiler

B215 NUMERICAL SIMULATIONS OF COMBUSTION OPTIMIZAITON FOR A 600 MW TENGENTIALLY COAL-FIRED SUPER-CRITICAL BOILER(Combustion-8)

Numerical Simulation of Combustion in 35 t/h Industrial Pulverized Coal Furnace with Burners Arranged on Front Wall

Influence of improving medium-speed pulverizer outlet temperature on the operation of boiler

Experimental research on the fire-carrying problems in primary air nozzle of 125 MW units

CFD modeling of hydrodynamics, combustion and NOx emission in a tangentially fired pulverized-coal boiler at low load operating conditions

Numerical Simulation of the Effect of Combustion Process on Flue Gas Thermal Deviation in 660MW Boiler

Numerical simulation on effects of over fire air on the combustion characteristics in an ultra-supercritical boiler

Simulation of Heat and Mass Transfer in Pulverized Coal Boiler Based on Gaseous Combustion Through Phase Separation Technique

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler

Numerical Simulation of Pulverized-coal Reburning Technology for a Large-sized Lignite-fired Boiler

An Investigation of New Methods for Attaining an Optimized Operation of Small and Medium-sized Pulverized Coal-fired Boilers

Numerical simulation investigations into the influence of the mass ratio of pulverized-coal in fuel-rich flow to that in fuel-lean flow on the combustion and NOx generation characteristics of a 600-MW down-fired boiler

Numerical Simulation and Performance Tests on Layered-combustion in a Tangential Coal-fired Double-furnace Boiler

Investigations on combustion optimization and NOX reduction of a 600-MWe down-fired boiler: Influence of rearrangement of tertiary air and jet angle of secondary air and separated over-fire air

Numerical Simulation Study on the Stable Combustion of a 660 MW Supercritical Unit Boiler at Ultra-Low Load

E305 NUMERICAL SIMULATIONS ON THE EFFECT OF OVER-FIRE AIR TO THE COMBUSTION PERFORMANCE IN A 2950 T/H TANGENTIAL-FIRED BOILER(Boiler-1)