Abstract:Purpose – Saturated core type superconducting fault current limiter (SFCL) can effectively limit the short-circuit current in power system. However, the high induced voltage will occur between the terminals of DC superconducting bias winding caused by the variation of magnetic flux linked by DC winding due to the increasing short-circuit current. The DC source may be damaged. Thus, the induced voltage should be considered in DC winding design. The paper aims to discuss these issues. Design/methodology/approach – Three-dimensional finite element method coupled with electric circuit. Findings – The short-circuit current flowing through AC windings and induced voltage of DC winding are analyzed by using three-dimensional finite element method coupled with electric circuit for a 220-kV three-phase SFCL. Several circuit elements, such as a capacitor connected with DC winding in parallel, an additional short-circuit winding wound around DC core column and an energy-released piezoresistor, are, respectively, used for induced voltage reduction. These methods aim to save magnetic coupled energy in DC winding, or oppose the variation of magnetic flux, or limit the voltage of DC winding by using a resistor with low resistance. Originality/value – The different methods for reduction of induced voltage of superconducting DC winding are studied and discussed. The decreased induced voltage may benefit the safety of superconducting DC winding and the source.

Distribution Parameter Extract of 500 Kv Current-limiting Inductors

Over-voltage Withstand Analysis of 500 kV Current-limiting Inductors

A Calculation Method Of Analytical Dc Fault Current In Mmc-Hvdc Grid Including Current-Limiting Devices

Voltage Distribution Analysis of 500-Kv Dc Transmission-Line Voltage Divider under Impulse Voltages: Stray Parameter Extraction

A Novel Six-Leg Three-Phase Fault Current Limiter

Hybrid Multifunctional Saturated-core Fault Current Limiter

Analysis of influence of a novel inductive fault current limiter on the circuit breaker in 500-kV power system

Effects of 500 kV Current-Limiting Inductors on Transient Recovery Voltage and Its Countermeasures

Optimization Of Current Breaker And Fault Current Limiter In Dc Micro-Grid Based On Faulty Transient Analysis

Ratios Of Current Limiting And Its Distribution In A Dc Resistive Superconducting Fault Current Limiter

Analysis of Key Factors Affecting the Non-Limiting State Reactance of Superconducting Fault Current Limiter

Effects of a Flux-Coupling Type Superconducting Fault Current Limiter on the Surge Current Caused by Closed-Loop Operation in a 10kv Distribution Network

Corona Ionized Field Analysis of±800kV HVDC Transmission Lines

Induced Voltage Analysis of Superconducting Fault Current Limiter

Effects of Current-Limiting Inductor on Power Frequency Overvoltages in Transmission Line

Fault Analysis of Multi-terminal DC Distribution System and Parameter Coordination of Protection Equipment

Research of HVAC Novel Fault Current Limiter Electromagnetic Field Coupling Considering the DC Component of Short Circuit Current

Research of Current-Limiting Effect of Transformer-Based Fault Current Limiters

Insulation Design Of Direct Current Resistive Type Superconducting Fault Current Limiter

Analysis of Short-time Withstand Current and Peak Withstand Current Test of 500kV AC Fault Current Limiter

Current Limiting Characteristic Analysis of Magnetic-controlled Switcher Type Fault Current Limiter