Abstract:The intelligent power distribution system based on VSC-DC has stimulated enormous research interest at home and abroad because of its variety of advantages, and overvoltage protection is one of the important research points. The lightning intruding overvoltage and protective measures of a ±10kV intelligent power distribution system is analyzed. First, according to the configuration of the ±10kV intelligent power distribution system, the modeling methods of high-frequency model of the converter under lightning is analyzed, and then the lightning intruding overvoltage simulation program of AC/DC yard is established by the PSCAD/EMTDC program. Secondly, the lighting overvoltage distribution of the equipment in converter and the influencing factors is analyzed in the case of direct-lightning and back flashover on the AC/DC transmission lines. At the same time, the lighting overvoltage of each equipment in the presence and absence of the L type arresters is compared. The simulation results show that, in the absence of the L-type arrester, the maximum withstand lightning current of VSC under shielding failure and back flashover is 50 k A/34 k A in AC and 28 k A/32 k A in DC, respectively. However, the withstand value of the lightning current is raised up to over 70 k A when the L-type arrester is configured in the system. Finally, according to the maximum lightning intruding overvoltage in both AC and DC yard, the configuration scheme of arresters is checked and the lightning impulse withstand voltage of the critical equipment is determined. The calculation results show that the insulation level of the switch equipment in DC side, the DC reactor and the converter transformer in AC side is all 60kV under the impact of lightning impulse, and the insulation level of the equipment of the DC bus and the converter transformer in DC side is 40kV.

Over-voltage Withstand Analysis of 500 kV Current-limiting Inductors

Distribution Parameter Extract of 500 Kv Current-limiting Inductors

Effects of Current-Limiting Inductor on Power Frequency Overvoltages in Transmission Line

Effects of 500 kV Current-Limiting Inductors on Transient Recovery Voltage and Its Countermeasures

A Calculation Method Of Analytical Dc Fault Current In Mmc-Hvdc Grid Including Current-Limiting Devices

Analysis of Short-time Withstand Current and Peak Withstand Current Test of 500kV AC Fault Current Limiter

Research on the Influence of Current Limiter Based on Highly Coupled Split Reactor on Main Circuit Breaker Overvoltage

Lightning Overvoltage Withstand of a ±800 Kv Smoothing Reactor

Study on overvoltage and insulation coordination of DC filter for ±800 kV UHVDC project from Xiangjiaba to Shanghai

Analysis of influence of a novel inductive fault current limiter on the circuit breaker in 500-kV power system

Effects of a Flux-Coupling Type Superconducting Fault Current Limiter on the Surge Current Caused by Closed-Loop Operation in a 10kv Distribution Network

Analysis of Transient Overvoltage in 220 Kv Saturated Core Hts Fcl

Overvoltage Estimation by Stray Inductances During Turn-off of a 500 Kv/25 Ka DC Circuit Breaker

Induced Voltage Analysis of Superconducting Fault Current Limiter

Winding Overvoltage Characteristic Analysis of Modular Cascade Isolating Energy Supply Transformer of ±500 kV Hybrid HVDC Breaker

Simulation on the Lightning Intruding Overvoltage of the ±10kV DC Distribution Network Based on VSC-DC

Simulation Study on Transient Process of Liquid Metal Current Limiter

Analysis of Key Factors Affecting the Non-Limiting State Reactance of Superconducting Fault Current Limiter

Mechanical & Thermal Stress Analysis under Actual Condition and Test Design of 550kv High Coupled Split Reactor

Application Analysis of Resistor Superconducting Fault Current Limiter in MMC-HVDC System

The Suitability Analyses of Sheath Voltage Limiters for HV Power Cable Transmission Lines