Abstract:Abstract Modeling the real contact area plays a key role in every tribological process, such as friction, adhesion, and wear. Contact between two solids does not necessarily occur everywhere within the apparent contact area. Considering the multiscale nature of roughness, Persson proposed a theory of contact mechanics for a soft and smooth solid in contact with a rigid rough surface. In this theory, he assumed that the vertical displacement on the soft surface could be approximated by the height profile of the substrate surface. Although this assumption gives an accurate pressure distribution at the interface for complete contact, when no gap exists between two surfaces, it results in an overestimation of elastic energy stored in the material for partial contact, which typically occurs in many practical applications. This issue was later addressed by Persson by including a correction factor obtained from the comparison of the theoretical results with molecular dynamics simulation. This paper proposes a different approach to correct the overestimation of vertical displacement in Persson’s contact theory for rough surfaces with self-affine fractal properties. The results are compared with the correction factor proposed by Persson. The main advantage of the proposed method is that it uses physical parameters such as the surface roughness characteristics, material properties, sliding velocity, and normal load to correct the model. This method is also implemented in the theory of rubber friction. The results of the corrected friction model are compared with experiments. The results confirm that the modified model predicts the friction coefficient as a function of sliding velocity more accurately than the original model.

Theory of Adhesion-Hysteresis-Fatigue of Elastomeric Tribology and Experimental Demonstration

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Rate-, state-, and pressure-dependent friction model based on the elastoplastic theory

Experimental study on seismic performance of laminated rubber bearings with friction slipping

Fatigue Life Assessment of Filled Rubber by Hysteresis Induced Self-Heating Temperature

Effect of modulation of interfacial properties on the tribological properties of viscoelastic epoxy resin damping coatings

Dependence of Adhesive Friction on Surface Roughness and Elastic Modulus

Simulation for Rubber Friction on Self-Affine Surface Based on Energy Method

Regional morphological difference and evolution of tread rubber and its formation mechanism under high-speed sliding friction

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings

Design of Elastic Cantilever for Friction Measurement

Impact Analysis of Worn Surface Morphology on Adaptive Friction Characteristics of the Slipper Pair in Hydraulic Pump

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Asperity-based modification on theory of contact mechanics and rubber friction for self-affine fractal surfaces

Adhesive contact mechanics of viscoelastic materials

An Integrated Approach for Friction and Wear Simulation of Tire Tread Rubber. Part I: Friction Test, Characterization, and Modeling

An innovative tensile test method to evaluate the effect of the loading rate on viscoelastic interfaces

Energy Dissipation on an Elastic Interface as a Metric for Evaluating Three Friction Models

Fatigue-resistant adhesion I. Long-chain polymers as elastic dissipaters

Effect of thermo-elastic deformation on lubricated point contacts